Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: Mittie Lee 1935
Forum: Model A (1928-31) 02-29-2024, 05:46 PM
Replies: 25
Views: 2,147
Posted By Mittie Lee 1935
Re: Nu Rex ignition switch

The strength of the Model A Club is the members! I was a member from 2002-2012 and after I sold my 1929 Tudor Sedan (big mistake) I dropped out. Now in 2024 as the 2 week old proud owner of a 1931...
Forum: Model A (1928-31) 02-29-2024, 01:01 PM
Replies: 25
Views: 2,147
Posted By Mittie Lee 1935
Re: Nu Rex ignition switch

Originally the pop out switch had the braided cable going to the distributor and a wire attached from the bat side (- ) of the coil. 2 other wires ran from the terminal to the amp guage and the car...
Forum: Model A (1928-31) 02-29-2024, 01:57 AM
Replies: 25
Views: 2,147
Posted By Mittie Lee 1935
Re: Nu Rex ignition switch

I’m not committed to going from the switch to-the terminal box I just want it to work. I didn’t understand that a wire was inside braided cable and ran to points. So reattaching a new braded cable by...
Forum: Model A (1928-31) 02-29-2024, 01:03 AM
Replies: 25
Views: 2,147
Posted By Mittie Lee 1935
Re: Nu Rex ignition switch

Thank you Jim and everyone for the help.
Forum: Model A (1928-31) 02-28-2024, 11:34 PM
Replies: 25
Views: 2,147
Posted By Mittie Lee 1935
Re: Nu Rex ignition switch

Thanks for the reply. So the instructions that came with the Nu Red switch says to run wire from junction box (was wire that was attached to original switch) to Batt terminal on new switch. So if I...
Forum: Model A (1928-31) 02-28-2024, 10:20 PM
Replies: 25
Views: 2,147
Posted By Mittie Lee 1935
Re: Nu Rex ignition switch

The original switch had only one wire [yellow] from terminal box attached to it and shielded cable going to distributor. Should I just run a wire from negative side of coil to batt terminal on switch...
Forum: Model A (1928-31) 02-28-2024, 08:42 PM
Replies: 25
Views: 2,147
Posted By Mittie Lee 1935
Nu Rex ignition switch

I Recently bought a 3 position Nu rex. Ignition switch that resembles the original but this one does not popout. My 1931 Ford has a single yellow wire that was attached to the original switch. I do...
Showing results 1 to 7 of 7

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 05:15 AM.