Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.07 seconds.
Search: Posts Made By: jw hash
Forum: Model A (1928-31) 10-09-2021, 07:20 PM
Replies: 9
Views: 494
Posted By jw hash
Re: Hand crank guide misalignment with ratchet nut

you do have the lower plate in backwards, and I can see where someone welded the front cross member is the top of it in the right location, and how does the hood fit. there could be a problem with...
Forum: Model A (1928-31) 10-01-2021, 07:40 AM
Replies: 3
Views: 211
Posted By jw hash
Re: 31 rdstr rumble fasteners

yes that is correct.
Forum: Model A (1928-31) 09-30-2021, 08:02 PM
Replies: 3
Views: 211
Posted By jw hash
Re: 31 rdstr rumble fasteners

the three fasteners for the panel is 1/4 20 x 5/8 stove bolts with lock washers and square nuts. the bolts for the rumble hinge brackets are 5/16 NF X 3/4 bolts with lock washers and one 1/4 20 X 5/8...
Forum: Model A (1928-31) 09-26-2021, 12:51 PM
Replies: 14
Views: 644
Posted By jw hash
Re: Rattling after installation of new water pump

the fan looks like it is not tight to the shaft, take a hold of the fan and check for it being loose.
Forum: Model A (1928-31) 09-21-2021, 09:05 AM
Replies: 16
Views: 694
Posted By jw hash
Re: Squeaking near front crank pulley

I had a similar problem. but mine would only squeak while driving down the road. turned out it was from the left engine pan rubbing on the front cross member. my car have float A motor mounts and the...
Forum: Model A (1928-31) 09-21-2021, 08:50 AM
Replies: 8
Views: 619
Posted By jw hash
Re: Model A Jim Beam collection

the yellow sports coupe I`m looking for is the same color as the yellow Police Phaeton NZ the answer is the lids are in the back of the decanters some under the trunks or the cargo.
Forum: Model A (1928-31) 09-20-2021, 08:12 PM
Replies: 8
Views: 619
Posted By jw hash
Re: Model A Jim Beam collection

the one I`m looking for is yellow. I past one up on Ebay a few years back. the black & yellow sports coupes are hard to find. but I know they are out there.
Forum: Model A (1928-31) 09-20-2021, 01:23 PM
Replies: 8
Views: 619
Posted By jw hash
Model A Jim Beam collection

I have 13 Model A Ford Jim Beam bottles collection. there was a total of 14 different ones made. I`m missing one. it is a yellow Sports Coupe. I`m hoping someone out there might have one and willing...
Forum: Model A (1928-31) 08-31-2021, 02:49 PM
Replies: 3
Views: 254
Posted By jw hash
Re: 1931 ford vicky paint color codes

Kawnee green is the lighter color, my Victoria is painted those colors.
Forum: Model A (1928-31) 08-24-2021, 10:27 PM
Replies: 1
Views: 188
Posted By jw hash
Re: Windshield Stanchion Cup Installation

yes they are spot welded in the stanchions. and sometimes the spot welds break loose. you can weld them in on the back side.
Forum: Model A (1928-31) 08-19-2021, 07:49 PM
Replies: 3
Views: 556
Posted By jw hash
Re: Identify These Shocks

those look to be reproductions made by Pete`s in Chicago years ago.
Forum: Model A (1928-31) 08-02-2021, 06:39 PM
Replies: 2
Views: 268
Posted By jw hash
Re: Clutch petal Grease Nipple Broken/Sheared

all the original ones for the pedals were the drive in type. and they had a little boss for them. i have drilled and taped 1/8 pipe and installed the grease fittings.
Forum: Model A (1928-31) 07-27-2021, 09:20 AM
Replies: 19
Views: 1,295
Posted By jw hash
Re: Broken clutch arm

clutch arms can break at anytime for a number of reasons. you do not have to pull the trans to replace the arm.
Forum: Model A (1928-31) 07-22-2021, 01:09 PM
Replies: 5
Views: 659
Posted By jw hash
Re: Straightening front bumper

I`m with john on this one. your front bumper irons, if the ends are bent wrong they can pull the center of the bumper in or out, and it does not take much to do it.
Forum: Model A (1928-31) 07-19-2021, 03:03 PM
Replies: 5
Views: 510
Posted By jw hash
Re: Window shaft seal

all of the slant window bodies used the window setting rubber with the extra lip that formed a seal between the window and the door opening. Snyder`s has it part #A-3401-SW there is some other years...
Forum: Model A (1928-31) 07-17-2021, 05:15 PM
Replies: 5
Views: 666
Posted By jw hash
Re: Trouble with repro light switch rod

sometimes someone uses the wrong wood drift key on the wheel. the wood drift key needs to be flat on the bottom, or you will push the slot down on the horn rod. take at 25/64 drill bit and run it...
Forum: Model A (1928-31) 07-17-2021, 05:02 PM
Replies: 3
Views: 415
Posted By jw hash
Re: Front Axle Markings

the early A`s and double A`s used the same front axles, then they went to bigger king pins, so if it is marked AA check the king pin holes
Forum: Model-A 07-17-2021, 01:47 PM
Replies: 0
Views: 243
Posted By jw hash
31 slant window interior panels

new never installed 31 slant window 160B interior panels, carpet, and assist straps. the color is brown mohair, not sure on the carpet. what you see is all I have. the carpet in complete. i do not...
Forum: Model A (1928-31) 07-12-2021, 09:35 AM
Replies: 19
Views: 1,785
Posted By jw hash
Re: looking for a ride

Freight carrier. we shopped for months to find a decent price. it was not cheap but it got there in good shape.
Forum: Model-A 07-11-2021, 09:54 PM
Replies: 0
Views: 229
Posted By jw hash
28-29 commercial heads

nicely restored 29-29 two bulb commercial head lights. all the correct plating. original lens, silver plated reflectors, cad plated inner parts,nickle plated rings. tested and ready to install SOLD ...
Forum: Model A (1928-31) 07-11-2021, 09:38 PM
Replies: 19
Views: 1,785
Posted By jw hash
Re: looking for a ride

the box made its way to WV thanks everyone
Forum: Model A (1928-31) 07-11-2021, 09:34 PM
Replies: 3
Views: 422
Posted By jw hash
Re: Door latch spring questions??

the broken spring looks correct. you have the broken parts in the wrong spot on the slide, it should go under that ear. i was hoping that i had one with the spring still on it. on that latch it is...
Forum: Model A (1928-31) 07-10-2021, 08:51 AM
Replies: 14
Views: 750
Posted By jw hash
Re: Seat springs

Snyder`s
Forum: Model A (1928-31) 06-30-2021, 02:28 PM
Replies: 9
Views: 672
Posted By jw hash
Re: Rear Fender Reinforcement.

Y blockhead PM sent
Forum: Model A (1928-31) 06-29-2021, 05:13 PM
Replies: 9
Views: 672
Posted By jw hash
Re: Rear Fender Reinforcement.

the coupe and pick up fenders use the same lower reinforcement. I save them off junk fenders.
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 02:27 AM.