Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 235
Search took 0.01 seconds.
Search: Posts Made By: jerrytocci
Forum: Model A (1928-31) 03-11-2024, 03:37 PM
Replies: 10
Views: 493
Posted By jerrytocci
Re: Ran great yesterday

UPDATE...The distributor shaft was caked with rust and would not move. It had popped out of the drive gear just enough to not turn. I don't get it. It fine the day before. I can only guess it is from...
Forum: Model A (1928-31) 03-10-2024, 10:00 PM
Replies: 10
Views: 493
Posted By jerrytocci
Re: Ran great yesterday

I know the screwdriver method. I asked what would make a snap by the firewall. Tomorrow I am going to give Blockheads theory a run.
Forum: Model A (1928-31) 03-10-2024, 05:24 PM
Replies: 10
Views: 493
Posted By jerrytocci
Ran great yesterday

Cranks over good but will not fire. Removed cap, body and rotor and loosened cam. turned ignition switch on and rotated cam by hand and heard snap from cowl area. Any ideas?
Forum: Model A (1928-31) 12-28-2023, 01:31 PM
Replies: 788
Views: 380,933
Posted By jerrytocci
Forum: Model A (1928-31) 12-13-2023, 10:31 AM
Replies: 21
Views: 2,168
Posted By jerrytocci
Re: Weird bolt in engine block

could be a tapped hole for a "non Ford " gen. bracket.
Forum: Model A (1928-31) 11-28-2023, 02:27 PM
Replies: 47
Views: 4,786
Posted By jerrytocci
Re: Abandoned roadster

Just what I need for my retirement years.
Forum: Model-A 10-09-2023, 08:43 PM
Replies: 0
Views: 452
Posted By jerrytocci
Zenith-1

$175.00 and I will mail to US address. 527572

527573

527574Post office money order. Carb was "test run" on my car. 527572527572

527573

527574
Forum: Model A (1928-31) 08-12-2023, 11:19 AM
Replies: 47
Views: 3,442
Posted By jerrytocci
Re: Welding Rear Springs

I would weld it. Test fit the bushing before assembly
Forum: Model A (1928-31) 08-08-2023, 07:57 PM
Replies: 29
Views: 2,121
Posted By jerrytocci
Re: fire wall does not match frame

32 rails are easy to identify. I think your firewall is too low. Lay the fuel tank in.
Forum: Model A (1928-31) 08-02-2023, 06:28 PM
Replies: 35
Views: 2,396
Posted By jerrytocci
Re: Cracked Block

I protected the radiator with cardboard, leaned a mirror against it and used a Dremel tool to prep the block. I used 2" clear tape to hold JB in place.
Forum: Model A (1928-31) 07-18-2023, 08:12 PM
Replies: 27
Views: 2,453
Posted By jerrytocci
Re: Frustrating start problem

Your problem is intermittent. I suspect an electrical connection issue effected by the temp and/or humidity. Good luck
Forum: Model A (1928-31) 07-13-2023, 10:12 AM
Replies: 15
Views: 2,016
Posted By jerrytocci
Re: Zenith drips

Any thoughts on an inline filter. I have one in the shut off. I leave the shut off in the on position, unless car sits for a while.
Forum: Model A (1928-31) 07-12-2023, 10:02 PM
Replies: 15
Views: 2,016
Posted By jerrytocci
Zenith drips

I have a pro rebuilt and it drips. What should I look for. Gas seems to drip from vent hole. Float is set at 3/4"
Forum: Model A (1928-31) 06-20-2023, 01:21 PM
Replies: 19
Views: 1,700
Posted By jerrytocci
Re: Water in tank

I bought gas treatment today and plan on using it , going forward(maybe even reverse)
Forum: Model A (1928-31) 06-20-2023, 10:12 AM
Replies: 19
Views: 1,700
Posted By jerrytocci
Re: Water in tank

It two qts. of water and gas mix
Forum: Model A (1928-31) 06-20-2023, 08:45 AM
Replies: 19
Views: 1,700
Posted By jerrytocci
Re: Water in tank

Thank you. It is a lot of fun and quite the attention getter.
Forum: Model A (1928-31) 06-20-2023, 08:43 AM
Replies: 19
Views: 1,700
Posted By jerrytocci
Re: Water in tank

Could the Florida climate do it?
Forum: Model A (1928-31) 06-19-2023, 09:26 PM
Replies: 19
Views: 1,700
Posted By jerrytocci
Forum: Model A (1928-31) 06-19-2023, 09:24 PM
Replies: 19
Views: 1,700
Posted By jerrytocci
Re: Water in tank

The gas station changed to Circle K day after I filled. That was about six weeks ago. My chassis is 1930 and has a home made wood body
Forum: Model A (1928-31) 06-19-2023, 08:15 PM
Replies: 19
Views: 1,700
Posted By jerrytocci
Water in tank

How can water get onto gas tank?? Been driving this car for one and a half years with no problems. The tank is lined. Yesterday the car died because of water. I removed the bowl and drained about two...
Forum: Model A (1928-31) 04-09-2023, 03:30 PM
Replies: 24
Views: 4,398
Posted By jerrytocci
Re: A common sight coming soon

I would' put that wand near a gas tank. They are dead until plugged in but I would not trust it
Forum: Model-A 04-07-2023, 01:54 AM
Replies: 1
Views: 533
Posted By jerrytocci
Forum: Model-A 04-06-2023, 09:28 PM
Replies: 1
Views: 533
Posted By jerrytocci
Custom body; Titled as a 28 Tudor

513394

513395

513396

513397

513398
Forum: Model A (1928-31) 03-07-2023, 09:32 PM
Replies: 44
Views: 5,721
Posted By jerrytocci
Re: 1929 model A model 180 on ebay????????

Door sill looks fiberglass.
Forum: Model A (1928-31) 01-20-2023, 07:48 AM
Replies: 70
Views: 9,232
Posted By jerrytocci
Showing results 1 to 25 of 235

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 04:32 PM.