Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Page 1 of 20 1 234511 Last »
Showing results 1 to 25 of 500
Search took 0.06 seconds. Search: Posts Made By: TJ
Forum: Early V8 (1932-53) Today, 10:42 AM
Replies: 5
Views: 105
Posted By TJ
Re: V-8 Times

I still don't have mine either here in Nor Calif. Just for info the the box of extra copies has also not arrived to those that handle the V-8 technical Books either.
Forum: Early V8 (1932-53) Yesterday, 07:46 PM
Replies: 17
Views: 423
Posted By TJ
Re: Correct replacement for Fram C181-A?

Different manufacturers sometimes use different size cartridge filters.
Forum: Early V8 (1932-53) Yesterday, 12:04 PM
Replies: 13
Views: 1,302
Posted By TJ
Re: 1934 sedan. Pulling out the gas tank

If you are pulling out the original tank to clean it and install a non original fuel sender why not buy a new tank that would be set up for the later sender? I seriously doubt that a modern sender...
Forum: Early V8 (1932-53) Yesterday, 11:56 AM
Replies: 6
Views: 338
Posted By TJ
Re: 1940 Trunk Layout

Trying to drill through welded up holes can be a serious challenge.
Forum: Early V8 (1932-53) 01-15-2021, 03:02 PM
Replies: 15
Views: 632
Posted By TJ
Re: The new 1940 Ford Book is now available

The V-8 Club does have a book that covers the '38-'39 cars. You can purchase it on the V-8 Club website. www.earlyfordv8.org.
Forum: Early V8 (1932-53) 01-15-2021, 02:57 PM
Replies: 10
Views: 976
Posted By TJ
Re: 1932 ford pickup GVWR.

See BobC's post. No need for GVW when 36 and older. Your DMV person should know that as in the vehicle code. Although I should not make assumptions on what Cal DMV knows or should know.
Forum: Early V8 (1932-53) 01-14-2021, 03:57 PM
Replies: 6
Views: 259
Posted By TJ
Re: Mid 50s F-100 parts

I've bought stuff from them and had good service.
Forum: Early V8 (1932-53) 01-14-2021, 03:26 PM
Replies: 15
Views: 632
Posted By TJ
Re: The new 1940 Ford Book is now available

Just got mine today and have briefly skimmed through it. Lots of great information for '40 lovers. Kube did a great job.
Forum: Early V8 (1932-53) 01-14-2021, 03:24 PM
Replies: 12
Views: 610
Posted By TJ
Re: which comes first...the windshield or the rubber seal

I think if you had titled your post with the words "1932 Cabriolet windshield seal" he probably would have noticed it right away.
Forum: Early V8 (1932-53) 01-14-2021, 11:10 AM
Replies: 12
Views: 610
Posted By TJ
Re: which comes first...the windshield or the rubber seal

The cabriolet takes a special seal and as I recall it installs in four pieces. I would put the frame in the car and have it loose and then tuck the seal between the frame and the body. As I recall...
Forum: Early V8 (1932-53) 01-13-2021, 09:04 PM
Replies: 12
Views: 1,180
Posted By TJ
Re: Grand Cherokee rear to 1935

With the leaf springs you may have to move the axle pads. With coil overs I have found that they are difficult to find the correct spring rates to make the car ride correctly whether it is loaded...
Forum: Early V8 (1932-53) 01-13-2021, 08:51 PM
Replies: 7
Views: 424
Posted By TJ
Re: 40 front seat-50k Rouge tudor like new!!

Dale, not found like that very often.
Forum: Early V8 (1932-53) 01-13-2021, 12:40 PM
Replies: 17
Views: 509
Posted By TJ
Re: Speedometer for 36 to S 10 tail shaft transmission?

The stock speedo cable should work if long enough. I have used the stock cable with a turbo 350 automatic and it worked just fine. The end that goes on the stock "turtle" should also go right on the...
Forum: Early V8 01-13-2021, 11:26 AM
Replies: 1
Views: 185
Posted By TJ
Re: 1941 Ford pickup hood handle

Btt
Forum: Early V8 (1932-53) 01-13-2021, 11:18 AM
Replies: 30
Views: 1,268
Posted By TJ
Re: who best to drop 1932 ford axle

I used Nostalgia Sid for '40 axle and he did a great job.
Forum: Early V8 (1932-53) 01-13-2021, 11:12 AM
Replies: 12
Views: 1,180
Posted By TJ
Re: Grand Cherokee rear to 1935

Use a parallel leaf spring kit from Chassis Engineering, TCI, or Speedway. I would not use anything with coil over shocks. The leaf spring kits are a "bolt-in"
kit and easy to install.
Forum: Early V8 (1932-53) 01-12-2021, 02:17 PM
Replies: 35
Views: 1,039
Posted By TJ
Re: Hagerty insurance ?

I have Grundy, but have friends who have Hagerty. Comparing notes when it comes to having a claim both companies respond very well and take care of the policy holder. I think you will find as I did...
Forum: Early V8 (1932-53) 01-12-2021, 11:34 AM
Replies: 9
Views: 345
Posted By TJ
Re: '40 floorboard seal

You can get a roll of black closed cell foam seal at your local hardware store to seal the top if you think you need it.
Forum: Early V8 (1932-53) 01-10-2021, 11:11 AM
Replies: 5
Views: 280
Posted By TJ
Re: 1940 ford column shift repair bushing

The rubber lined grommets for the shift arms can be purchased as a kit from most of the V-8 parts vendors.
Forum: Early V8 (1932-53) 01-10-2021, 11:02 AM
Replies: 6
Views: 286
Posted By TJ
Re: 40 2 door window felts, channel,rubber ???

The window channel kits are supplied by Vintique to most if not all V-8 retailers. I get the rubber seals from Drake if they are in stock.
Forum: Early V8 (1932-53) 01-10-2021, 10:58 AM
Replies: 34
Views: 846
Posted By TJ
Re: V8 times

Still waiting here in Nor Cal.
Forum: Early V8 (1932-53) 12-28-2020, 03:59 PM
Replies: 24
Views: 678
Posted By TJ
Re: Oh What Fun It Is To Ride

The HiCountry regional group has hosted some fantastic meets in the past and I made most of them, Too bad Covid spoiled the 2020 meet. You belong to a great group and nice roadster too.
Forum: Early V8 (1932-53) 12-25-2020, 11:23 AM
Replies: 3
Views: 140
Posted By TJ
Re: Happy Holidays

Great looking '41 pickup. Merry Christmas.
Forum: Early V8 (1932-53) 12-24-2020, 12:58 PM
Replies: 4
Views: 214
Posted By TJ
Re: 46 Ford inside door opener spring

That spring should be available from your favorite V-8 vendor. It can be a little tricky to change.
Forum: Early V8 (1932-53) 12-24-2020, 12:56 PM
Replies: 7
Views: 204
Posted By TJ
Re: Merry Christmas to all

Great photo and Merry Christmas to all here on the Barn.
Showing results 1 to 25 of 500
Page 1 of 20 1 234511 Last »

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 02:47 PM.