Forum: Model A (1928-31)
04-23-2022, 07:19 PM
|
|
Replies: 33
Views: 1,408
|
|
Forum: Model A (1928-31)
04-16-2022, 02:44 PM
|
|
Replies: 2
Views: 508
|
|
Forum: Model A (1928-31)
10-14-2021, 01:53 PM
|
|
Replies: 41
Views: 3,223
Re: Consensus of opinion
The p.o. of my car installed a generator from a late model flat head. The voltage regulator is mounted on the firewall. I’ve had over 40 years of trouble free driving. I have never seen this set up...
|
|
Forum: Model A (1928-31)
08-17-2021, 07:46 PM
|
|
Replies: 10
Views: 1,165
|
|
Forum: Model A (1928-31)
05-30-2021, 10:06 AM
|
|
Replies: 2
Views: 422
Coil test, how long?
I read about a coil test that involves getting a bright blue spark from the secondary wire, then leaving the key on and points closed and doing it again. How long do I wait between the two...
|
|
Forum: Model A (1928-31)
05-21-2021, 07:32 PM
|
|
Replies: 37
Views: 3,732
Re: Boat Anchor
What speed are you shifting at? I get the same result as you if I shift under 20mph.
|
|
Forum: Model A (1928-31)
04-04-2021, 06:34 PM
|
|
Replies: 16
Views: 2,091
Re: Distributor dilemma
The folks who offered suggestions to my dilemma deserve to know the outcome. Yesterday I read the thread “ no spark” and there it was. Would you believe I left the rotor out?
|
|
Forum: Model A (1928-31)
03-28-2021, 07:02 PM
|
|
Replies: 16
Views: 2,091
Distributor dilemma
Spring is here and I went to start the car. I always clean the points to begin with. Next I shorted the points with a screw driver and got a bright blue 1/2” spark from the high voltage wire. Put...
|
|
Forum: Model A (1928-31)
12-30-2020, 08:15 PM
|
|
Replies: 4
Views: 735
|
|
Forum: Model A (1928-31)
12-14-2020, 05:24 PM
|
|
Replies: 33
Views: 2,781
|
|
Forum: Model A (1928-31)
12-13-2020, 09:35 PM
|
|
Replies: 33
Views: 2,781
Re: headlight current tied to ignition switch?
I hooked up my dash light to the wire going to the tail light. Now if the parking lights or headlights are still on when I turn the key off I got a visual reminder. No goofs since I did this.
|
|
Forum: Model A (1928-31)
10-12-2020, 12:15 PM
|
|
Replies: 11
Views: 1,455
Silica gel desiccant
A friend saves these packages and puts them in the screen in his model a gas tank over the winter. I did a google search and found that kitty litter is the same chemical. I would appreciate any...
|
|
Forum: Model A (1928-31)
03-30-2020, 01:36 PM
|
|
Replies: 2
Views: 887
Gas damage on rubber
I accidentally got gasoline on my running board and didn’t notice until the next day. The rubber is now blistered or wavy. Can the damage be repaired? It’s not where it will be stepped on.
Thanks,...
|
|
Forum: Model A (1928-31)
02-28-2020, 08:33 PM
|
|
Replies: 12
Views: 1,455
Re: Very dirty filter bowl
Werner, when I had a similar problem I installed a dirty leg. When the rust clears up I will install the correct valve and pencil filter. If you are not sure what I’m talking about, do a google...
|
|
Forum: Model A (1928-31)
02-05-2020, 04:38 PM
|
|
Replies: 55
Views: 6,845
spark plug caps
Hi all, I was just looking at a Restoration Supply Co. catalog and noticed something called “spark plug caps”. I must admit I like the look of 3X and other vintage brass capped spark plugs. Anybody...
|
|
Forum: Model A (1928-31)
08-06-2019, 06:21 PM
|
|
Replies: 21
Views: 2,829
Re: Speaking of shocks . .
Don’t forget about rebuilt originals. I bought a set from John Holland of Valley City Ohio and so far so good.
|
|
Forum: Model A (1928-31)
08-02-2019, 04:23 PM
|
|
Replies: 8
Views: 1,613
Re: Clutch shudder and horseshoe shims
To clarify, when the clutch pedal is pushed down 1/4", the throw out bearing begins to touch at least one of the fingers on the pressure plate. The clutch pedal can easily be pressed down one inch...
|
|
Forum: Model A (1928-31)
08-02-2019, 03:17 PM
|
|
Replies: 8
Views: 1,613
Clutch shudder and horseshoe shims
I recently replaced my clutch when I could no longer shift without grinding the gears. I assumed my problem was a spring slipping out of place on the clutch disk. What I found was a broken rivet. I...
|
|
Forum: Model A (1928-31)
06-08-2019, 08:28 PM
|
|
Replies: 6
Views: 1,342
Transmission tower spring removal
Hello barners, a friend has loaned me a tool to remove the shifter spring. This is the one all the vendors sell and Les Andrew describes. Can it be used with the forks in place ?I’m only familiar...
|
|
Forum: Model A (1928-31)
05-15-2019, 11:40 AM
|
|
Replies: 2
Views: 785
|
|
Forum: Model A (1928-31)
04-28-2019, 08:57 PM
|
|
Replies: 9
Views: 1,524
Window glass
Hi all, my local club had a vehicle inspection day today and we were unsure how to distinguish between tempered glass and plate glass. Laminated glass was no problem of course. Any suggestions?
|
|
Forum: Model A (1928-31)
02-04-2019, 02:47 PM
|
|
Replies: 38
Views: 5,439
|
|
Forum: Model A (1928-31)
12-25-2018, 11:01 AM
|
|
Replies: 7
Views: 1,045
Re: wheel size
Merry Christmas all. I should point out that pick-ups did not change all at once to the new style in 1930. I almost bought a 1930 open cab pick-up that still had the 1928/29 body style but then again...
|
|
Forum: Model A (1928-31)
11-02-2018, 05:02 PM
|
|
Replies: 8
Views: 1,371
Diamond B i.d.
I know this is unimportant but I'm curious. The engine in my car is a model B. It has the small diamond in the casting but there is no date code. Is this common?
|
|
Forum: Model A (1928-31)
10-20-2018, 06:36 PM
|
|
Replies: 36
Views: 9,374
Re: model B motor in model A chassis
No problem, that's what I'm running right now. You must make one change to your timing procedure: instead of setting the timing with the spark lever all way up(retard) put the lever 1/2 way down.
|
