Forum: Model A (1928-31)
01-02-2023, 09:16 AM
|
Replies: 5
Views: 2,263
Re: Stipe Oil pumps
Thank you for your reply. I will be working on two Burtz motors and was options for Oil Pumps and to what pressures I can get. looks like you were able to get a comfortable pressure with Bill's Pump....
|
Forum: Model A (1928-31)
01-01-2023, 03:36 PM
|
Replies: 5
Views: 2,263
Stipe Oil pumps
Looking for detailed information for hot and cold pressures and at what RPM's. Also is Bill still in business, I see the web site does not work.
|
Forum: Model A (1928-31)
07-14-2022, 09:15 AM
|
Replies: 9
Views: 1,170
|
Forum: Model A (1928-31)
07-13-2022, 02:28 PM
|
Replies: 9
Views: 1,170
|
Forum: Model A (1928-31)
07-13-2022, 12:06 PM
|
Replies: 9
Views: 1,170
|
Forum: Model A (1928-31)
07-13-2022, 12:04 PM
|
Replies: 7
Views: 1,355
|
Forum: Model A (1928-31)
07-13-2022, 06:15 AM
|
Replies: 7
Views: 1,355
New Radiators
Does anyone know if Berg's expertise in building quality radiators was passed onto to another supplier? Please suggest other recommended vendors. Quality as in Gery's is more important than cost. We...
|
Forum: Model A (1928-31)
07-13-2022, 06:02 AM
|
Replies: 9
Views: 1,170
"T" & "A" Springs
Looking to purchase a new rear "A" Spring. Is Travis Cook still taking orders?
|
Forum: Model A (1928-31)
01-20-2021, 10:05 AM
|
Replies: 6
Views: 1,322
|
Forum: Early V8 (1932-53)
07-24-2018, 07:20 PM
|
Replies: 1
Views: 877
1949 F8 Steering Wheel
Need to remove the steering wheel, to remove column from truck. Found that the column box will not fit up through floor. Any suggestions.
|
Forum: Early V8
12-29-2017, 09:43 AM
|
Replies: 0
Views: 799
|
Forum: Model A (1928-31)
07-30-2016, 01:18 PM
|
Replies: 36
Views: 6,521
Re: Xmission Oil
Tam's is the only supplier that I'm aware of selling the correct 600W. Use straight from container. Available in quarts or gallons.
|
Forum: Early V8 (1932-53)
03-24-2016, 03:24 PM
|
Replies: 4
Views: 1,629
Re: 35' Truck Headlight Rim Problem
Thank you all, I ended up bending out the tabs some, to get the latch past the end of tab. The bracket that Bob Drake is is using is the same as a Model A part. The length to the pivot point is short...
|
Forum: Early V8 (1932-53)
03-22-2016, 08:05 AM
|
Replies: 4
Views: 1,629
Re: 35' Truck Headlight Rim Problem
I have had the glass installed inn them for a while, I did find the wrapper from the glass and they were from Vintique. Not positive they were from them also. They were purchased from a NY supplier....
|
Forum: Early V8 (1932-53)
03-21-2016, 08:20 PM
|
Replies: 4
Views: 1,629
35' Truck Headlight Rim Problem
Working on installing the lens rings. Purchased new ones and cannot get the latch to go over the retainers. I compared them to an original, the only difference I can find is the length of the latch...
|
Forum: Early V8
03-12-2016, 04:42 PM
|
Replies: 1
Views: 847
|
Forum: Early V8
03-08-2016, 04:14 PM
|
Replies: 1
Views: 847
1936 1 /1/ ton Steering Wheel , Batt. Tray
I'm looking for a 4 Spoke Steering wheel and a Battery Tray. I think the correct part # for tray is 51-5151. I'm not working on a show truck, so looking for a usable wheel. I can repair a tray if...
|
Forum: Early V8 (1932-53)
03-04-2016, 07:47 PM
|
Replies: 11
Views: 1,579
Re: hardware for '36 instruments
The instrument studs are for sure 10-32. Ace carries the hardware you need. I just did this work on a 36 1 1/2 ton truck. Had to repair for one stud that was broke off. Drilled and taped to use a...
|
Forum: Early V8 (1932-53)
02-11-2016, 08:42 PM
|
Replies: 1
Views: 1,062
|
Forum: Early V8 (1932-53)
02-10-2016, 11:10 AM
|
Replies: 1
Views: 1,062
36' 1 1/2 Ton Truck
Looking for contacts to locate a Battery Tray that mounts in the corner of frame and cross member under floor board.
|
Forum: Early V8 (1932-53)
02-08-2016, 08:29 AM
|
Replies: 172
Views: 42,861
|
Forum: Early V8
01-26-2016, 08:09 PM
|
Replies: 0
Views: 473
|
Forum: Model A (1928-31)
06-12-2015, 08:11 PM
|
Replies: 25
Views: 7,422
Re: Barn fresh AA farm truck
I own a 1930 AA 1 1/2 Ton Stake Body. My truck has been completely restored since 1985. If you have any questions or would like to stop by to see my truck let me know, as I live close to you near...
|
Forum: Model A (1928-31)
06-04-2015, 08:28 PM
|
Replies: 1
Views: 1,186
Late 31-Early 32 Ignition Switch
Working on a Panel Delivery that has a On/Off switch, Not a Pop Out type. The keys are Briggs & Stratton #C399 Round Head. Was this used as a replacement switch? Is this type acceptable for Touring...
|
Forum: Model A (1928-31)
05-13-2015, 06:58 AM
|
Replies: 3
Views: 1,677
Re: Foot Rest Base
Thank you Marco. I'm I correct in saying that the flat is vertical on the left?
|