Forum: Model A (1928-31)
08-27-2012, 03:44 PM
|
Replies: 7
Views: 2,147
Re: Starter problems?
Thanks for the replies. I have tried cranking it by hand, but it was very hard for me to turn the crank. I have never cranked one before so I don't know how much resistance I should experience as I...
|
Forum: Model A (1928-31)
08-26-2012, 08:12 PM
|
Replies: 7
Views: 2,147
Re: Starter problems?
Thanks for the suggestions. I did try to crank by hand, but I could hardly turn the crank! I'll loosen the starter tomorrow, rock the car in third, and if that doesn't work I'll order a new switch....
|
Forum: Model A (1928-31)
08-26-2012, 06:57 PM
|
Replies: 7
Views: 2,147
Starter problems?
My 29 Tudor has been starting fine until yesterday. I started it, ran it for a while, turned it off, tried to start it again, and absolutely nothing. I checked the battery and I have 6.24 volts both...
|
Forum: Model A (1928-31)
07-20-2012, 08:34 PM
|
Replies: 18
Views: 4,978
|
Forum: Model A (1928-31)
06-26-2012, 09:26 PM
|
Replies: 20
Views: 5,666
Re: Hinge pins?
I have recently removed the top hinge pins on my29 Tudor. I first ground the top and bottom of the pins so that I had flat surfaces. I then found the center of the pin, and used a 12inch long by 3/8...
|
Forum: Model A (1928-31)
06-20-2012, 09:10 PM
|
Replies: 14
Views: 3,087
|
Forum: Model A (1928-31)
06-11-2012, 08:26 PM
|
Replies: 40
Views: 16,782
|
Forum: Model A (1928-31)
06-04-2012, 09:38 PM
|
Replies: 10
Views: 1,965
Re: Tire Pressure
It is my understanding that the brand of the tire will dictate the tire pressure. When I bought my 29 Tudor it had new tires and I noticed the tube valve stem was projecting from one wheel on an...
|
Forum: Model A (1928-31)
05-28-2012, 08:45 PM
|
Replies: 14
Views: 2,799
|
Forum: Model A (1928-31)
05-28-2012, 08:33 PM
|
Replies: 14
Views: 2,799
Re: Need help with steering
King bee
Yes, I read that the steering box takes 600 wt. oil, but the steering box on my car has a zerk fitting on the top. Wow! I just looked at the drawing of the 7 tooth steering box in the...
|
Forum: Model A (1928-31)
05-28-2012, 07:23 PM
|
Replies: 14
Views: 2,799
Need help with steering
I got to drive my 29Tudor today for the first time. It was very difficult to keep it within my lane. Before I drove it, I put the front end on jack stands, greased every fitting I could see,...
|
Forum: Model A (1928-31)
04-27-2012, 07:24 PM
|
Replies: 11
Views: 4,459
Re: Fan removal
Again I say thanks. I worked on it today, put it back on the motor and cannot start the car because I am waiting for a new sediment bulb gasket which is on its way, along with other parts, from...
|
Forum: Model A (1928-31)
04-26-2012, 08:55 PM
|
Replies: 11
Views: 4,459
Re: Fan removal
I thank each of you for Your suggestions. As you can probably tell, this is my first model A and I have a lot to learn! I have a four blade metal fan integrated with the pulley. Yes, I am going to...
|
Forum: Model A (1928-31)
04-26-2012, 05:48 PM
|
Replies: 11
Views: 4,459
Fan removal
I started to rebuild the water pump on my 29 Tudor and I am not able to remove the fan and pulley from the shaft. I see that Snyder's sells a tool for this but I wold like to get the job done and not...
|
Forum: Model A (1928-31)
04-16-2012, 10:25 PM
|
Replies: 12
Views: 2,699
Re: Need help with cooling system
Thanks for all your comments and suggestions. I really appreciate each of you taking the time to help a novice "newby", and I will proceed with your suggestions. I know I am really going to enjoy...
|
Forum: Model A (1928-31)
04-14-2012, 05:50 PM
|
Replies: 12
Views: 2,699
Need help with cooling system
As you can probably tell, I am new to this forum. I purchased a 1929 Model A Tudor last Monday. This is my first Model A and I am excited about it. It was drivable, but I live 50 miles from where I...
|
Forum: Model A (1928-31)
04-08-2012, 08:17 PM
|
Replies: 19
Views: 3,231
Re: HAPPY EASTER to ALL
I am new to the forum and as a pastor I know I am really going to enjoy it here. I will pick up my 1929 Tudor tomorrow, and will probably be asking many questions as this is my first model A. May...
|