Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 44
Search took 0.01 seconds.
Search: Posts Made By: steven a
Forum: Model A (1928-31) 10-02-2020, 10:09 AM
Replies: 3
Views: 336
Posted By steven a
Cabriolet folding top Turning lock

Need information my knobs are missing and one lock broken off Pictures would help
Forum: Early V8 12-25-2018, 01:44 PM
Replies: 0
Views: 342
Posted By steven a
60 hp.

Rebuilt 60 hp. Engine Complete including NOS starter and exhaust manifolds on a stand but never fired mile 38 off I 75 . 513 571-5276
Forum: Model A (1928-31) 07-08-2017, 02:15 PM
Replies: 18
Views: 1,644
Posted By steven a
Re: After you sell...how the heck do you ship ??

1 radiator , get a box from a radiator shop 2. wheels , band them to a pallet 3. fender , stop by a couple of body shops the usually have a fender box . best to have buyer send his shipper to pick up...
Forum: Early V8 (1932-53) 07-04-2017, 04:14 PM
Replies: 6
Views: 588
Posted By steven a
1950 vs 1952 oil pan

I had to change oil pans so I could install an E-Z Steer on my 50 ford .. This required me to remove the 52 pan and install the 50 oil pan with 3 robs on the side . Now I'm getting a knock from the...
Forum: Early V8 (1932-53) 06-24-2017, 05:18 PM
Replies: 9
Views: 1,402
Posted By steven a
Re: bob drake flathead carburator

fuel drips from the accelerator pump . I talked to a gentleman at a car show his is worse also a Bob Drake Carb . These are new repro not cheap .
Forum: Early V8 (1932-53) 06-20-2017, 02:38 PM
Replies: 9
Views: 1,402
Posted By steven a
bob drake flathead carburator

Any else having trouble with leaking accelerator pump leaking . I got mine from Mac Van Pelt . Mac says Drake wants me to ship it to them they will look at it and since its past one year they will...
Forum: Early V8 06-18-2017, 05:45 PM
Replies: 0
Views: 446
Posted By steven a
oil pan

wanted 49-50 oil pan must have 3 ribs on sides of pan
Forum: Questions & Suggestions 06-02-2017, 02:00 PM
Replies: 3
Views: 879
Posted By steven a
Forum: Questions & Suggestions 06-02-2017, 01:58 PM
Replies: 3
Views: 1,124
Posted By steven a
Re: ID my roadster

you could get $6-800 for that title
Forum: Late V8 04-22-2017, 02:30 PM
Replies: 0
Views: 433
Posted By steven a
f 1 pickup

1949 pickup Kansas farm truck with 58000 miles very solid surface rust only Eng changed to a 312 Mercury Y block and automatic .I have the inside replacement head and kick panels . Seat redone in...
Forum: Early V8 04-22-2017, 02:03 PM
Replies: 0
Views: 285
Posted By steven a
1939 Rebuilt 60 HP

Rebuilt complete 60 HP engine . Complete includes new starter water pumps clutch 81 carb. fuel pump dist. on a stand never fired . pick up here all new inside .
Forum: Model-A 04-22-2017, 01:54 PM
Replies: 0
Views: 676
Posted By steven a
Model A engine

I'm posting this for a friend . This was his back up engine . Rebuilt and ready to install . As he recalls it's a 1931 engine from a low mileage car , He had it gone through with new valves and valve...
Forum: Model A (1928-31) 01-23-2016, 04:23 PM
Replies: 31
Views: 3,990
Posted By steven a
Re: Electric draw with key off

And throw that pop out switch away . They all fail sometime , but you never know when
Forum: Model A (1928-31) 01-23-2016, 04:21 PM
Replies: 31
Views: 3,990
Posted By steven a
Re: Electric draw with key off

When the diode goes bad they can have a slight draw and still charge ok. Try leaving the alt. disconnected
Forum: The Test Forum 01-23-2016, 04:08 PM
Replies: 3
Views: 1,627
Posted By steven a
Re: 1950 ford custom flat head

We used to put a film of oil on the surface of the plate with our fingers when we put them together . But the last one I unstuck I put a chain from rear of the car to a pickup , a little push to...
Forum: Questions & Suggestions 01-23-2016, 04:00 PM
Replies: 2
Views: 742
Posted By steven a
Re: Model A rear end gears

go for the 327 gear
Forum: Early V8 08-31-2015, 12:28 PM
Replies: 0
Views: 587
Posted By steven a
1936 ford

restored 1936 ford 4 door trunk back ,Black with gray interior runs great . Located near Dayton Ohio . A very solid car new WW Cookers . 513 571 5276
Forum: Early V8 07-08-2015, 03:12 PM
Replies: 0
Views: 986
Posted By steven a
Flathead engine

Rebuilt Engine , still on stand . You can hear it run ! !949 ford pickup engine Dist . on top . Hoses on front of head . painted Ford green . Sounds great , pistons 30 over crank 20 under ....
Forum: Early V8 (1932-53) 04-13-2015, 11:17 AM
Replies: 8
Views: 1,120
Posted By steven a
Re: truck beds

the year
Forum: Early V8 (1932-53) 04-12-2015, 11:37 AM
Replies: 8
Views: 1,120
Posted By steven a
truck beds

On a 1949 and 50 ford half ton was did one bed come with a wood floor and the other steel ? and how should the ser. # start Thanks for the help Steve
Forum: Early V8 04-04-2015, 02:51 PM
Replies: 0
Views: 991
Posted By steven a
35 Five window coupe

For Sale , 1935 Del. Coupe roll down back window , factory radio . WW tires .L B interior is new . 1946 221 cu.in. Diamond Block engine . 39 fod hyd brakes . New chrome , needs final paint . Runs...
Forum: Early V8 04-04-2015, 12:39 PM
Replies: 0
Views: 774
Posted By steven a
For Sale

1936 Del four dr. Trunk sedan , older restoration still looks Great . New Cooker WW . Drives and stops good . Nice car , call me at 513 571 52 76 before 7 pm. $19,500 cash or wire transfer .
Forum: Early V8 (1932-53) 03-31-2015, 02:48 PM
Replies: 0
Views: 568
Posted By steven a
vin plate

i have a 49 mercury , the vin. plate may have been moved during a long ago engine compartment repaint . Id like to see a picture of an origional plate on a 1949 coupe . Some say that different plants...
Forum: Late V8 (1954+) 03-18-2015, 02:35 PM
Replies: 20
Views: 3,688
Posted By steven a
Re: 302 Windsor or Cleveland?

windsor block isn't as wide
Forum: Early V8 (1932-53) 03-18-2015, 02:16 PM
Replies: 5
Views: 817
Posted By steven a
36 ford tr. back std. or deluxe

How can I tell if my 36 trunk back is a standard or dexuxe model
Showing results 1 to 25 of 44

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 12:17 PM.