Forum: Model A (1928-31)
02-26-2021, 06:43 PM
|
|
Replies: 22
Views: 1,033
|
|
Forum: Model A (1928-31)
02-12-2021, 02:17 PM
|
|
Replies: 33
Views: 1,766
|
|
Forum: Model A (1928-31)
01-16-2021, 04:25 PM
|
|
Replies: 22
Views: 1,256
Re: converting to 1970 v8 points for model a
I have been running the modern points with the wireless contact from Bert's for the last five years since my rebuilt. Still the same set with no problems. I lube the cam with a little Vaseline...
|
|
Forum: Model A (1928-31)
11-21-2020, 10:30 AM
|
|
Replies: 48
Views: 3,644
Re: Hard Brake Pedal
When only the front or rear brakes are connected maybe you are getting full travel of the rods. Combined the might be preventing full travel. I would check the rod length adjustments.
|
|
Forum: Model A (1928-31)
11-18-2020, 03:17 PM
|
|
Replies: 27
Views: 1,248
|
|
Forum: Model A (1928-31)
11-10-2020, 04:32 PM
|
|
Replies: 15
Views: 1,269
|
|
Forum: Model A (1928-31)
11-07-2020, 01:10 PM
|
|
Replies: 21
Views: 1,759
|
|
Forum: Model A (1928-31)
09-22-2020, 04:52 PM
|
|
Replies: 13
Views: 1,062
|
|
Forum: Model A (1928-31)
08-29-2020, 07:26 PM
|
|
Replies: 34
Views: 1,821
|
|
Forum: Model A (1928-31)
08-04-2020, 02:09 PM
|
|
Replies: 25
Views: 1,096
Re: Annoying rattle.
If my A didn't have a rattle somewhere, I'd be worried that all the parts fell off.
|
|
Forum: Model A (1928-31)
06-12-2020, 11:19 AM
|
|
Replies: 16
Views: 1,781
Re: More kudos to Bert's Model A Center
Bought my very first Model A in late 2013. Didn't know anything about them. After driving for about a year and a half I found pieces of Babbitt in the oil after a change. Was told to shut it down...
|
|
Forum: Model A (1928-31)
05-30-2020, 12:33 PM
|
|
Replies: 18
Views: 1,267
|
|
Forum: Model A (1928-31)
05-11-2020, 01:39 PM
|
|
Replies: 54
Views: 3,142
Re: Distributor stuck
I used two large screwdrivers wedged under the body on each side of the shaft and resting on top of the water return bulge on top of the head,(for lack of a better description). Gently tapped both...
|
|
Forum: Model A (1928-31)
02-12-2020, 02:16 PM
|
|
Replies: 6
Views: 651
|
|
Forum: Model A (1928-31)
02-03-2020, 07:45 PM
|
|
Replies: 8
Views: 915
Re: steering box
Don't use grease to lube the steering box. Since it is not a liquid it won't flow between the gears thus drying them out. It will just be displaced by the gears. Use the proper gear oil to lube the...
|
|
Forum: Model A (1928-31)
01-06-2020, 01:26 PM
|
|
Replies: 7
Views: 823
|
|
Forum: Model A (1928-31)
01-03-2020, 01:15 PM
|
|
Replies: 9
Views: 819
Re: Remote oil Filter Adp
Using the adapter I fill the filter with oil before installing it to shorten the pause in circulation since it holds almost a quart of oil. I don't know if this is necessary but it doesn't hurt to...
|
|
Forum: Model A (1928-31)
01-02-2020, 02:56 PM
|
|
Replies: 8
Views: 668
Re: Happy new year
My New Year's resolution I made years ago was not to make any. So far I've kept it. Happy New everyone and enjoy your A's this year!!
|
|
Forum: Model A (1928-31)
12-27-2019, 02:54 PM
|
|
Replies: 8
Views: 1,133
|
|
Forum: Model A (1928-31)
12-23-2019, 11:58 AM
|
|
Replies: 15
Views: 1,245
Re: Rotor Position Question
That picture is a good starting point. With the points set at .020 I tweak the rotor after the initial setting driving it with the lever about midway until it responds well and goes up my little test...
|
|
Forum: Model A (1928-31)
12-19-2019, 11:57 AM
|
|
Replies: 12
Views: 1,288
Re: power disconnect switch
I cut a round hole in the floor board, mounted the switch on the cross member supporting the front seat. The switch handle sits just below the floor surface allowing me to make a round sheet metal...
|
|
Forum: Model A (1928-31)
12-18-2019, 12:15 PM
|
|
Replies: 16
Views: 873
|
|
Forum: Model A (1928-31)
12-14-2019, 03:47 PM
|
|
Replies: 18
Views: 1,470
Re: GAV knob proper orientation
It doesn't really where the "fin" is located. Check where it is in the closed position and adjust it from there where it runs the best. I think that each car runs a little differently. Mine is in...
|
|
Forum: Model A (1928-31)
11-25-2019, 10:29 AM
|
|
Replies: 49
Views: 7,170
Re: Oil Filter Model A on timing cover
I have that kit installed on mine for the last 5 years and it works just fine. When I installed it I loosened the return tube to see if there was a restriction due to the filter and there was none. ...
|
|
Forum: Model A (1928-31)
11-23-2019, 04:38 PM
|
|
Replies: 26
Views: 3,843
Re: Cast-iron brake drum fit
Brent, I have always enjoyed your posts with all the info they provide. I was told awhile back that woven linings are too hard for cast iron drums and that bonded linings are recommended for them. ...
|
