Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 93
Search took 0.01 seconds.
Search: Posts Made By: aaron griffey
Forum: Early V8 (1932-53) 06-24-2012, 02:29 AM
Replies: 13
Views: 7,987
Posted By aaron griffey
Re: Do you have a Ford Flathead V8 H-block?

When I was in the Army in Germany in '56 to '59 we used German Ford trucks to haul laundry.
They were flat head V8's with the distributor behind the rt. cylinder head.
I had already owned a '33 a...
Forum: Model A (1928-31) 06-23-2012, 05:46 PM
Replies: 38
Views: 11,640
Posted By aaron griffey
Re: four blade vs. two blade fan

The four blade fan was installed in 1934 by dealers for customers that complained about running too hot.
I have not checked it out myself but supposedly on a slow hard pull the four blade fan will...
Forum: Model A (1928-31) 06-23-2012, 05:35 PM
Replies: 16
Views: 9,767
Posted By aaron griffey
Re: tighten rear axle nut

I have replaced more than a dozen rear axles on early Fords because the owner or mechanic insisted on just leaving the nut finger tight.
On V8 it will shear the key but a T or an A it will most...
Forum: Model-A 06-23-2012, 01:20 PM
Replies: 2
Views: 988
Posted By aaron griffey
Re: Model A steering columns

I'll take a steering colum, I need one for a '30.

Aaron Griffey (5100415-1219
[email protected]
Forum: Model-A 06-23-2012, 01:14 PM
Replies: 2
Views: 1,320
Posted By aaron griffey
want axle shaft

Need good used axle shaft for a model A.

Aaron Griffey (510)4151219
[email protected]
Forum: Model-A 11-01-2011, 12:39 AM
Replies: 4
Views: 990
Posted By aaron griffey
Need steering column for a '30

I need a steering column mast jacket for a '30 model A.
Will buy a complete column if you have one.
Forum: Early V8 (1932-53) 10-21-2011, 11:34 AM
Replies: 12
Views: 3,168
Posted By aaron griffey
Re: Grundy Antique Car Insurance

A very close friend is insured with Hagerty.
Last year his car was totaled by a rear-ender. He and his wife were both injured.
The insurance company paid them off for the car and fought for them...
Forum: Model A (1928-31) 10-21-2011, 11:25 AM
Replies: 16
Views: 4,144
Posted By aaron griffey
Re: Use of RTV on Rear Main

Damn!! the stuff you learn on these forums! I didn't know that.

"Anerobic" means that the sealer is the type that cures when you seal off the air supply.
I like it in some places because you...
Forum: Model A (1928-31) 10-18-2011, 10:29 PM
Replies: 12
Views: 3,591
Posted By aaron griffey
Re: Rumble seat danger!

I know a guy who got a warning from a cop that saidyou can't have people in the rumble seat while on a public road or highway anymore.???
Forum: Model A (1928-31) 10-17-2011, 09:58 PM
Replies: 10
Views: 5,500
Posted By aaron griffey
Re: 6 v + grd. turn signal audio alarm solution:

Auto Zone has a louder 12 volt flasher I've been putting in my 12 volt cars.
Not too loud but loud enough to notice.
Not model A related but my Chrysler Town & Country sounds a chime if the...
Forum: Model A (1928-31) 10-16-2011, 05:52 PM
Replies: 6
Views: 1,662
Posted By aaron griffey
Re: front cross member

Bert's does not have one for a '30. Thanks to all who have posted on this subject.
I've been around model A cars and a few trucks the last 60+ years and never knew about the solid front mount before.
Forum: Model A (1928-31) 10-16-2011, 04:12 PM
Replies: 10
Views: 1,903
Posted By aaron griffey
Re: Head bolts

Model T Fords had coarse bolts. When changing to a high compression head most Many good T builders use model A head studs. Especially with high compression heads.
In order to get the same gasket...
Forum: Model A (1928-31) 10-16-2011, 12:45 PM
Replies: 6
Views: 1,662
Posted By aaron griffey
Re: front cross member

Thanks folks.
So how can I tell the early from the late?
I need one for a '30.
Forum: Model A (1928-31) 10-16-2011, 11:20 AM
Replies: 6
Views: 1,662
Posted By aaron griffey
front cross member

Is the front cross member of the frame the same for all years of Model A?
Forum: Model A (1928-31) 10-16-2011, 12:13 AM
Replies: 10
Views: 4,833
Posted By aaron griffey
Re: laycock volvo overdrive oil

The Volvos used 80-90 except when they had an overdrive.
In the overdrive equipped cars the transmission bearings were different and the trans and overdrive used ATF.
Since there is a clutch in...
Forum: Early V8 (1932-53) 10-15-2011, 06:37 PM
Replies: 12
Views: 2,074
Posted By aaron griffey
Re: Brake Problem

I just did a '40 Buick this year that had 0ne front and the single rear hose plugged.
It's not uncommon to find a hose jammed up with it's own material
Forum: Early V8 (1932-53) 10-15-2011, 06:34 PM
Replies: 12
Views: 2,074
Posted By aaron griffey
Re: Brake Problem

Swap shoes from one side to the other. Then reread 40CPE's post.
Forum: Early V8 (1932-53) 10-15-2011, 06:29 PM
Replies: 16
Views: 3,389
Posted By aaron griffey
Re: Home Made Car with Six Flatheads (Pics)

Now if you could chain the together with a bike chain on the sprockets of each and synchronized them so that 2 had the pistons up, one was half way down, one half way up and the remaining two were...
Forum: Model A (1928-31) 10-12-2011, 11:09 PM
Replies: 40
Views: 16,901
Posted By aaron griffey
Re: Model A fatal reared ended crash in Montana.

Suppose it had been a big-rig that just pulled into the lane from a stop on the shoulder and was doing 45MPH.
It would be the one that rear ended the other that was injured and the one that got hit...
Forum: Model-A 10-12-2011, 11:23 AM
Replies: 3
Views: 1,215
Posted By aaron griffey
Re: 30-31 'A' front crossmember

I need one too. Do you have another front crossmember?
(510)415-1219

[email protected]

Thanks
Forum: Model-A 10-12-2011, 11:08 AM
Replies: 0
Views: 981
Posted By aaron griffey
'30 front cross member wanted

I need a front cross member for a '30 Model A.
510-415-1219
Forum: Late V8 11-05-2010, 10:46 PM
Replies: 2
Views: 1,289
Posted By aaron griffey
61 Ford overdrive trans.

3 speed overdrive transmission out of an early sixties full sized Ford. Complete with bell housing. $100.
[email protected] ([email protected]) 510-415-1219
Forum: Early V8 10-21-2010, 01:48 PM
Replies: 0
Views: 1,162
Posted By aaron griffey
Need up-draft C.O.E. carb

I need a used up-draft carb for a Ford 6 from '41 on. I have rebuilt that is missing the idle mixture jet and screw.
[email protected]
51-415-1219
Forum: Early V8 10-21-2010, 01:42 PM
Replies: 1
Views: 964
Posted By aaron griffey
Up draft carb wanted.

Need used updraft Cab-over engine carb for 6 cylinder Ford truck '41 and later. Condition not important. I have a rebuilt with no idle mixure screw.
[email protected]
Forum: Model A (1928-31) 08-25-2010, 11:09 PM
Replies: 82
Views: 56,378
Posted By aaron griffey
Re: Model A Fords and Ford 2.0 and 2.3 engines

The years after '67 all SAAB cars had the V4. Including the 2 door sedans and station wagons.
I put a Pinto 2 liter motor, 4 speed trans and sedan rear end (about 3.78) in a '29 Nah. It is about...
Showing results 1 to 25 of 93

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 07:43 PM.