Forum: Model T (1909-1927)
02-25-2021, 11:58 AM
|
|
Replies: 14
Views: 428
Re: side lights
Yes, he is quite proud of those - I might have an original set available - I'll check.
|
|
Forum: Model T (1909-1927)
02-24-2021, 10:15 PM
|
|
Replies: 14
Views: 428
Re: side lights
If the photo you have in your profile is your T then these are the brackets you need - I'm with Mark on the subject - if you like & want oil side lamps, by all means install them !
|
|
Forum: Model T (1909-1927)
02-24-2021, 11:28 AM
|
|
Replies: 14
Views: 428
Re: side lights
I would suggest attempting to locate original Ford STEEL brackets - last thing you want is to have a cheap repro bracket break & drop your side lamp on the road !
|
|
Forum: Model T (1909-1927)
02-22-2021, 11:30 AM
|
|
Replies: 5
Views: 193
|
|
Forum: Model T (1909-1927)
02-16-2021, 06:09 PM
|
|
Replies: 40
Views: 991
Re: New member with "new" 1922 Model T
There are 2 brass petcocks towards the rear of the crankcase on the carburetor side of the engine - oil level is midway between the 2 BUT it ALWAYS needs to come out of the bottom one ! Make sure...
|
|
Forum: Model-A
02-01-2021, 08:40 PM
|
|
Replies: 4
Views: 295
|
|
Forum: Model-A
02-01-2021, 09:50 AM
|
|
Replies: 4
Views: 295
|
|
Forum: Model A (1928-31)
01-28-2021, 09:24 PM
|
|
Replies: 18
Views: 1,019
|
|
Forum: Model T (1909-1927)
01-26-2021, 05:33 PM
|
|
Replies: 5
Views: 308
|
|
Forum: Model T (1909-1927)
01-24-2021, 10:36 PM
|
|
Replies: 5
Views: 308
|
|
Forum: Model-A
01-23-2021, 06:59 PM
|
|
Replies: 4
Views: 295
|
|
Forum: Model A (1928-31)
01-21-2021, 02:16 PM
|
|
Replies: 18
Views: 1,019
|
|
Forum: Model-A
01-20-2021, 10:37 AM
|
|
Replies: 4
Views: 295
|
|
Forum: Model A (1928-31)
01-19-2021, 05:43 PM
|
|
Replies: 18
Views: 1,019
|
|
Forum: Model-A
01-19-2021, 01:14 PM
|
|
Replies: 4
Views: 295
|
|
Forum: Model A (1928-31)
01-18-2021, 01:55 PM
|
|
Replies: 18
Views: 1,019
|
|
Forum: Model T (1909-1927)
11-27-2020, 11:20 AM
|
|
Replies: 8
Views: 571
Re: Distributer
Reliability depends on if it's an "era" distributor or a modern conversion. Replacement parts for "era" installs can be hard to come by whereas modern distributor parts are readily available. Can...
|
|
Forum: Model T (1909-1927)
11-16-2020, 01:58 PM
|
|
Replies: 7
Views: 1,096
Re: Water pump shaft nut
You might consider tightening the pak nut while the engine is idling to prevent it locking up the shaft - after tightening & shutting down, make sure upon the next re-start, you verify the fan belt...
|
|
Forum: Model T (1909-1927)
10-21-2020, 10:01 AM
|
|
Replies: 5
Views: 714
|
|
Forum: Model T (1909-1927)
10-07-2020, 09:22 AM
|
|
Replies: 8
Views: 1,265
|
|
Forum: Model T (1909-1927)
09-17-2020, 10:12 AM
|
|
Replies: 3
Views: 694
Re: How do you test a magneto coil ring?
Quick test with a battery charger - connect the red lead to the solder button, the black lead ground to coil frame, energize then place a short piece of flat bar or a bolt on two coils at a time - it...
|
|
Forum: Model A (1928-31)
09-16-2020, 11:39 AM
|
|
Replies: 30
Views: 1,773
|
|
Forum: Model A (1928-31)
09-10-2020, 11:07 AM
|
|
Replies: 21
Views: 1,057
|
|
Forum: Model A (1928-31)
09-02-2020, 10:03 AM
|
|
Replies: 22
Views: 1,347
Re: Best Replacement Radiator
I appreciate the comments - Like Terry above, I own & operate a small Model T repair shop and am helping a friend with his "new to him" Model A - he's not mechanically inclined and is having some...
|
|
Forum: Model A (1928-31)
08-31-2020, 05:28 PM
|
|
Replies: 17
Views: 1,319
|
