Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 9 of 9
Search took 0.00 seconds. Search: Posts Made By: john charlton
Forum: Model A (1928-31) 07-03-2020, 11:07 AM
Replies: 51
Views: 7,155
Posted By john charlton
Re: Can't separate axle shaft from carrier

Just a thought adjust the brakes hard up on the adjuster then back fully off and try again . This could centralise the shoes maybe not but worth a try . Could be with the new axle shafts the drums...
Forum: Model A (1928-31) 06-12-2020, 03:28 AM
Replies: 51
Views: 7,155
Posted By john charlton
Re: Can't separate axle shaft from carrier

Thank you Tom Sadly I did send the wrong side to Daniel .OOOOPS !!!. But in my defence it was marked A4205 and was not scalloped so visually it looked correct I did not pickup the fact the notches...
Forum: Model A (1928-31) 06-11-2020, 04:01 PM
Replies: 51
Views: 7,155
Posted By john charlton
Re: Can't separate axle shaft from carrier

The part I sent you had the correct part number on it so I assumed it was correct . My mistake I should have tried a ring gear on it before I went to the post office !!! So your good part is the same...
Forum: Model A (1928-31) 06-03-2020, 07:44 AM
Replies: 51
Views: 7,155
Posted By john charlton
Re: Can't separate axle shaft from carrier

The above assumes the pinion bearing has correct preload .Knew I would forget something !!!

John
Forum: Model A (1928-31) 06-03-2020, 06:21 AM
Replies: 51
Views: 7,155
Posted By john charlton
Re: Can't separate axle shaft from carrier

The Les book is correct . This is the way I do it . I put the diff carrier in the complete axle setup with no axles or spider fitted the ring gear is fitted tightly to the carrier . The torque tube...
Forum: Model A (1928-31) 06-02-2020, 05:50 AM
Replies: 51
Views: 7,155
Posted By john charlton
Re: Can't separate axle shaft from carrier

Yes better lubrication I have your PM .

John
Forum: Model A (1928-31) 06-02-2020, 04:36 AM
Replies: 51
Views: 7,155
Posted By john charlton
Re: Can't separate axle shaft from carrier

This is the carrier I have if you pay the postage it is yours for free PM me your address if you are interested .Do you do Pay Pal ?

John
Forum: Model A (1928-31) 06-02-2020, 04:18 AM
Replies: 51
Views: 7,155
Posted By john charlton
Re: Can't separate axle shaft from carrier

Hi Daniel .You cannot repair the carrier you have it would cause the spider gears to be misaligned to the axle gear which will damage the axle . The carrier halves are not "matched" like the ring...
Forum: Model A (1928-31) 06-01-2020, 02:10 PM
Replies: 51
Views: 7,155
Posted By john charlton
Re: Can't separate axle shaft from carrier

Hi Bay Arian I will check to see what I have here in England as I am closer than USA so postage should be cheaper . Can you get a good used axle in Germany or are you going to buy a new one from a...
Showing results 1 to 9 of 9

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 06:23 PM.