Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 21 of 21
Search took 0.00 seconds.
Search: Posts Made By: dbknorr
Forum: Model A (1928-31) 03-13-2023, 02:51 PM
Replies: 13
Views: 1,628
Posted By dbknorr
Re: Differential Leaking - bent axle housing?

Thanks to all for your comments. Sounds like my situation is not unusual but I need to seal the bolt holes. Again thanks to all in a great hobby.
Forum: Model A (1928-31) 03-13-2023, 01:13 PM
Replies: 13
Views: 1,628
Posted By dbknorr
Differential Leaking - bent axle housing?

My differential is leaking badly on the driver's side. When installing the radius rods, the driver's side rod was about 1/4" short of the bolt holes on the axle housing. With much difficulty using...
Forum: Model A (1928-31) 02-07-2023, 01:06 PM
Replies: 0
Views: 442
Posted By dbknorr
Wanted - Pattern for rear arm rests 31 SW 4 dr.

I need a pattern to make the wood side arm rests for the back seat of my 31 Slant Windshield Town Sedan. Original wood pieces would be good too. Dan Knorr 575-937-4758.
Forum: Model-A 11-29-2022, 01:06 PM
Replies: 0
Views: 414
Posted By dbknorr
Need Dash Rail for 31 Slant Windshield Town Sedan

Need a Dash Rail for 31 Slant Windshield. Can trade another rail or buy outright. Dan Knorr
[email protected]
575-937-4758
Forum: Model-A 11-14-2022, 09:45 PM
Replies: 0
Views: 537
Posted By dbknorr
Need Robe Rope for 31 Slant Windshield Town Sedan

I need the robe rope for a 31 SW Town Sedan. I have the brackets but need the rope.
Forum: Model-A 11-01-2022, 11:27 PM
Replies: 0
Views: 417
Posted By dbknorr
Wanted - Robe cord brackets for 160B

Still looking for the robe cord brackets to fit Slant Windshield 4 door Town Sedan.
Forum: Model-A 10-04-2022, 10:01 AM
Replies: 0
Views: 496
Posted By dbknorr
Wanted - Robe cord brackets, Headlight Inner rings, Eschutcheons

Need two robe cord brackets for Slant Windshield Town Sedan (160B). This is the AB bracket shown in Judging Standards p. 12-10.

Also need two inner rings for 30,31 headlights.

Need 10...
Forum: Model-A 08-29-2022, 09:47 PM
Replies: 0
Views: 332
Posted By dbknorr
Wanted Dome light for 31 SW Town Sedan

Still looking for a dome light for 31 Slant Windshield Town Sedan. It is the plain oval.
Forum: Model-A 08-17-2022, 04:24 PM
Replies: 0
Views: 394
Posted By dbknorr
Wanted Trico TR-C2A and Dome lamp for 31 SW Town Sedan

I need a Trico vacuum windshield wiper assembly with the extended shaft for a Slant Windshield Town Sedan. Also need an Oval Dome Lamp assembly A-13776-0 for the same car.
Forum: Model A (1928-31) 11-08-2021, 02:35 PM
Replies: 15
Views: 1,478
Posted By dbknorr
Re: SW Town Sedan - Source or plans for rear seat wood.

I checked Classic Wood today and they said they don’t make the rear seat cushion or back rest wood.
Forum: Model A (1928-31) 11-08-2021, 09:54 AM
Replies: 15
Views: 1,478
Posted By dbknorr
Re: SW Town Sedan - Source or plans for rear seat wood.

Cape Codder - thanks for the response and offer to measure but I am pretty sure the wood on a SW 4dr is different than a Tudor. Thanks again.
Forum: Model A (1928-31) 11-06-2021, 04:18 PM
Replies: 15
Views: 1,478
Posted By dbknorr
Re: SW Town Sedan - Source or plans for rear seat wood.

It is my understanding that all Slant Windshield Town Sedans are 1931 and were built to a Ford design. Bodies were built by Murray, Briggs and Ford but all would be essentially the same. Let me...
Forum: Model A (1928-31) 11-06-2021, 02:11 PM
Replies: 15
Views: 1,478
Posted By dbknorr
SW Town Sedan - Source or plans for rear seat wood.

I need to buy or build the rear seat cushion and backrest wood for a SW Town Sedan. Have not found a source but could use plans to build. Any information appreciated.
Forum: Model A (1928-31) 11-02-2021, 10:32 AM
Replies: 6
Views: 620
Posted By dbknorr
Forum: Model A (1928-31) 11-01-2021, 10:40 PM
Replies: 6
Views: 620
Posted By dbknorr
SW Town Sedan - what material is used for tack strip above doors?

I have removed the rope like material that is used for a tack strip above the doors of a SW 4 door. There are two parallel troughs above the doors with tabs every 4 inches or so to hold the rope...
Forum: Model A (1928-31) 02-23-2020, 12:54 AM
Replies: 5
Views: 3,865
Posted By dbknorr
Re: Need 2 Victoria Assist Straps

Thanks for your suggestion, I will give Lee a call.
Forum: Model A (1928-31) 02-22-2020, 10:14 AM
Replies: 5
Views: 3,865
Posted By dbknorr
Need 2 Victoria Assist Straps

Does anyone know a source for Victoria Assist Straps? I need a pair of the taupe straps.
Forum: Model A (1928-31) 01-01-2020, 04:37 PM
Replies: 5
Views: 1,346
Posted By dbknorr
Re: How do you lock a 31 Victoria?

Thank you all for your responses. Totally answered my question. Dan
Forum: Model A (1928-31) 12-29-2019, 09:32 PM
Replies: 5
Views: 1,346
Posted By dbknorr
Thumbs down How do you lock a 31 Victoria?

I am restoring a 31 Vicky and have a locking exterior door handle for the right door. How is the latch for the left side locked from the inside to prevent the door from being opened from the...
Forum: Model-A 01-19-2019, 11:49 AM
Replies: 0
Views: 603
Posted By dbknorr
Wanted 30 or 31 New Mexico License Plates

Looking for original or restored 1930 or 1931 NM matched license plates.
Forum: Model-A 01-06-2019, 09:03 PM
Replies: 0
Views: 1,051
Posted By dbknorr
Victoria rear valence and right quarter window frame

I need the right rear window frame and a rear valence for my Victoria project. Please contact direct at [email protected]
Showing results 1 to 21 of 21

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 01:48 PM.