Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.04 seconds.
Search: Posts Made By: John Kuhnast
Forum: Model A (1928-31) 01-26-2017, 10:53 AM
Replies: 344
Views: 41,084
Posted By John Kuhnast
Re: Just wondering : what's your year of birth ?

My year is 1934. When I had my 1931 Sport coup in 1953 and needed a part I just went to the Ford dealer. Remember buying a new hand brake for $5.00
Forum: Model A (1928-31) 01-10-2017, 03:16 PM
Replies: 6
Views: 1,016
Posted By John Kuhnast
Welcome aboard

Model A guy goes to get on a bus. He is carrying a drive shaft. Driver says you can't get on here company will not allow any package over four feet and that is five feet. Model A guy goes into a...
Forum: Model-A 12-21-2016, 12:59 PM
Replies: 0
Views: 822
Posted By John Kuhnast
drive shaft and torque tube

Drive shaft a torque tube Good used no rust $300
Forum: Model A (1928-31) 12-17-2016, 02:46 PM
Replies: 1
Views: 928
Posted By John Kuhnast
carburetor float valve

Rebuilding a tillotson carburetor.Looking for recommendations on what type of float valve to use. maybe a viton plastic tip? Whats recommended and where can I get one? Thank you
Forum: Model A (1928-31) 12-17-2016, 11:52 AM
Replies: 12
Views: 1,629
Posted By John Kuhnast
Re: 1931 shutoff grommet install

Thanks heat and grease and its in
Forum: Model A (1928-31) 12-14-2016, 10:34 AM
Replies: 10
Views: 1,884
Posted By John Kuhnast
Re: Unusual oil filler cap

Thats a Model T oil can.
Forum: Model A (1928-31) 12-14-2016, 10:32 AM
Replies: 12
Views: 1,629
Posted By John Kuhnast
Unhappy 1931 shutoff grommet install

Any trick to installing the rubber grommet in the fire wall before installing the under hood shutoff valve.Its putting up a good fight and so far its winning.
Forum: Model A (1928-31) 11-22-2016, 09:28 AM
Replies: 10
Views: 1,520
Posted By John Kuhnast
Re: 31 AA - Gas Valve Rebuild Kit?

Don't know if my late 31 {on firewall under the hood] is original or repro. When the handle points to front of car valve is closed when it points to the passenger side valve is open.Is that an...
Forum: Model A (1928-31) 11-21-2016, 02:51 PM
Replies: 4
Views: 1,158
Posted By John Kuhnast
Late 1931 indented firewall gas valve

Looking for advice on my gas valve which has a slight leak when off. Brattons sells a replacement valve. They also sell a gas line which has a valve in the line, They have a fuel valve Stem which...
Forum: Model-A 11-15-2016, 12:44 PM
Replies: 6
Views: 1,267
Posted By John Kuhnast
Forum: Model-A 11-15-2016, 12:44 PM
Replies: 8
Views: 1,504
Posted By John Kuhnast
Forum: Model-A 11-15-2016, 12:43 PM
Replies: 3
Views: 980
Posted By John Kuhnast
Forum: Model-A 11-07-2016, 09:39 AM
Replies: 3
Views: 980
Posted By John Kuhnast
Forum: Model-A 11-07-2016, 09:39 AM
Replies: 8
Views: 1,504
Posted By John Kuhnast
Forum: Model-A 11-07-2016, 09:38 AM
Replies: 6
Views: 1,267
Posted By John Kuhnast
Forum: Model A (1928-31) 11-07-2016, 08:56 AM
Replies: 14
Views: 1,982
Posted By John Kuhnast
Re: Aspen Hill Shopping Center Car Show

I drive a 1931 pick up. Most people say nice car?
Forum: Model A (1928-31) 10-31-2016, 02:19 PM
Replies: 12
Views: 2,202
Posted By John Kuhnast
Tow tooth steering adjustment

Im working on adjusting my two tooth box.All is tight except when moving the pitman arm from front to back of car. I have about 1/8 inch play.This is in the box The bolt from pitman arm to shaft is...
Forum: Model A (1928-31) 10-27-2016, 09:37 AM
Replies: 33
Views: 6,975
Posted By John Kuhnast
Re: Gas shutoff valve handle direction

I Thought I was the only one. On my late 31 under hood I regent The handle so it is in line with the pipe when on and at right angles when off.
Forum: Model A (1928-31) 10-23-2016, 10:12 AM
Replies: 124
Views: 31,249
Posted By John Kuhnast
Re: Our Model A wreck in Austin, TX

Synchro 909 has what I think is a good thought. After stoping at a red light I had a car come very close to hitting me. Im sure they saw me. Could it be that it did not dawn on them that I was a car?...
Forum: Model-A 10-23-2016, 09:45 AM
Replies: 6
Views: 1,267
Posted By John Kuhnast
Forum: Model-A 10-23-2016, 09:44 AM
Replies: 8
Views: 1,504
Posted By John Kuhnast
Forum: Model-A 10-23-2016, 09:43 AM
Replies: 3
Views: 980
Posted By John Kuhnast
Forum: Model A (1928-31) 10-23-2016, 09:40 AM
Replies: 8
Views: 1,474
Posted By John Kuhnast
Forum: Model A (1928-31) 10-22-2016, 02:17 PM
Replies: 8
Views: 1,474
Posted By John Kuhnast
1931 Gas valve removal

Planning on removing the under hood gas valve on my 1931 and polish the seat to stop some seepage. Can I just unscrew it from the engine side or is it necessary for someone to hold it under the gas...
Forum: Model A (1928-31) 10-22-2016, 07:31 AM
Replies: 4
Views: 788
Posted By John Kuhnast
Re: Gas gauge Late 1931

Thank you gentlemen Il follow your advice. Good job for this winter.
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 07:20 PM.