Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 48
Search took 0.01 seconds.
Search: Posts Made By: fuzes45
Forum: Model A (1928-31) Today, 08:45 AM
Replies: 8
Views: 284
Posted By fuzes45
Re: Source for epoxy-filled 6 volt coil ?

Try FS Ignitions, may be able to help. I am running their ignition system.
Bob
Forum: Model A (1928-31) 10-16-2020, 11:59 AM
Replies: 20
Views: 847
Posted By fuzes45
Re: Taillight bulbs

With only left you would be ready for NASCAR
Forum: Model A (1928-31) 09-17-2020, 01:06 PM
Replies: 8
Views: 488
Posted By fuzes45
Re: Coating the armature . . .

Building transformers, dipped coil in Varnish and baked.


Bob F
Forum: Model A (1928-31) 08-12-2020, 01:06 PM
Replies: 14
Views: 603
Posted By fuzes45
Re: Clutch pressure plate New or Reconditioned?

New ones made in China. Junk


Bob
Forum: Model A (1928-31) 07-26-2020, 08:44 AM
Replies: 8
Views: 676
Posted By fuzes45
Re: Transmission stuck

I had trans problems, replaced everything from pilot bearing back to u joint.
Would jump out of gear down hill, could not up shift.Got two old units and replaced bearings but 2nd gear noisy but...
Forum: Model A (1928-31) 07-03-2020, 02:41 PM
Replies: 48
Views: 5,448
Posted By fuzes45
Re: Introducion

PU pick up a truck.
Nice Dog
Forum: Model A (1928-31) 06-26-2020, 09:16 AM
Replies: 16
Views: 1,049
Posted By fuzes45
Re: Ct swap meet 6-28

Location Marlborough, Ct Just west of center on Rt 66.


Exit 13 off Rt 2 to Rt 66


Bob F
Forum: Model A (1928-31) 06-26-2020, 09:13 AM
Replies: 10
Views: 598
Posted By fuzes45
Re: luggage rack

With spare on 30 Coupe needed to install bracket extensions, to clear tire.



There are brackets that are thicker , so if a heavy load in trunk go for more robust ones.


Bob F
Forum: Model A (1928-31) 06-26-2020, 09:10 AM
Replies: 7
Views: 722
Posted By fuzes45
Re: Brassworks 28 Show Quality vs Active Driver?

Bought a Bergs radiator, installed a Vintage t housing with 160 degree stat


runs cooler than original that was flushed and tested professionally.


I would look int Bergs vs brassworks.

...
Forum: Model A (1928-31) 06-25-2020, 08:44 AM
Replies: 33
Views: 4,964
Posted By fuzes45
Re: Gas shutoff valve handle direction

Snyders sells Gas Valve Magnet, you can stick on gas tank


Bob F
Forum: Model A (1928-31) 06-24-2020, 12:04 PM
Replies: 16
Views: 1,049
Posted By fuzes45
Re: Ct swap meet 6-28

Carter Farm "Antique Auto Swap Meet" Billed by them as "The summer version of Powder Mill Barn swap Meet" Said pre 1963 auto parts and memorabilia. no mention of Cars.
On 28th 7-11 info Matt 860...
Forum: Model A (1928-31) 06-24-2020, 09:43 AM
Replies: 16
Views: 1,049
Posted By fuzes45
Re: Ct swap meet 6-28

Belltown show in August cancelled, Haddam neck fair grounds will have no shows this year. Club planning to have a tour only.
The 27 Show at Xavier High 10 to 2 $10
28th 7am to 11am Carter hill farm...
Forum: Model A (1928-31) 06-22-2020, 07:17 PM
Replies: 7
Views: 550
Posted By fuzes45
Re: 29 light switch

Go to Brattons and click on Wiring harness there is instructions showing


modifications to light switch disk.


Bob F
Forum: Model A (1928-31) 06-07-2020, 06:13 AM
Replies: 39
Views: 2,122
Posted By fuzes45
Re: Which Car-Like Vehicles Can Tow a Model A?

Son had Ford Explorer with independent rear axle, towing boat approx 3000# above
40 mph swayed all over road, if you have class 1 hitch on vehicle limited as what you can tow. Some rental agencies...
Forum: Model A (1928-31) 04-30-2020, 03:21 PM
Replies: 54
Views: 2,299
Posted By fuzes45
Re: Irregular Signal Flashing

Be sure to ground the pigtail wire on the flasher to chassis ground.


Same one i installed


Bob f
Forum: Model A (1928-31) 04-18-2020, 03:17 PM
Replies: 54
Views: 2,299
Posted By fuzes45
Re: Irregular Signal Flashing

ledlight.com has solid state flasher and led bulbd


Bob F
Forum: Model A (1928-31) 04-11-2020, 09:50 AM
Replies: 23
Views: 1,431
Posted By fuzes45
Re: Not running

Remove plug from bottom of carb, not bolt that holes the halfs togeather and see
if gas flows thru carb.
Bob
Forum: Model A (1928-31) 03-25-2020, 09:10 AM
Replies: 54
Views: 8,704
Posted By fuzes45
Re: Floorboard bolts/cup washers

Bought some from Mc-Master-Carr
Bob
Forum: Model A (1928-31) 03-10-2020, 02:44 PM
Replies: 3
Views: 550
Posted By fuzes45
Re: Head Studs

In les book he gives dimension for stud height, will give correct amount so studs go through nut.
Bob
Forum: Model A (1928-31) 03-10-2020, 02:41 PM
Replies: 30
Views: 1,199
Posted By fuzes45
Re: Using Parking Lights For Signal Lights

Have Parking lights that were added by previous owner, Replaced all bulbs with LED,


A lot brighter, some LED ones have optional colors. Stop and running lights brighter.


No mods to sockets....
Forum: Model A (1928-31) 02-02-2020, 02:00 PM
Replies: 4
Views: 693
Posted By fuzes45
Radiator emblem

On 1930 Radiator shell, emblem removal. Not sure how to remove.No nut.


Thanks Bob
Forum: Model A (1928-31) 01-20-2020, 08:56 AM
Replies: 28
Views: 1,576
Posted By fuzes45
Forum: Model A (1928-31) 01-11-2020, 08:42 AM
Replies: 15
Views: 1,049
Posted By fuzes45
Re: Conventional oil and Synthetic oil

Oil for vehicles over 75000 miles has additive to slightly swell seals to help prevent leakage.
Bob
Forum: Model A (1928-31) 01-09-2020, 01:28 PM
Replies: 41
Views: 3,562
Posted By fuzes45
Re: Revising gear box

The adjustable strap, acts alike a sling to support transmission when installing, or put
pipe in drain hole for floor jack to lift transmission.


Hope that explains info. Bob
Forum: Model A (1928-31) 01-05-2020, 03:39 PM
Replies: 41
Views: 3,562
Posted By fuzes45
Re: Revising gear box

Use the adjustable strap around trans to dash board brackets to help support and hold
when putting trans in.
Bob
Showing results 1 to 25 of 48

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 09:47 PM.