Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.06 seconds.
Search: Posts Made By: Benson
Forum: Model A (1928-31) 10-22-2020, 01:48 PM
Replies: 10
Views: 305
Posted By Benson
Re: Differential Gear Ratio Determination

fyi:


3.54 = 11 39


4.56 = 9 41
Forum: Model A (1928-31) 10-10-2020, 11:37 AM
Replies: 21
Views: 1,264
Posted By Benson
Re: Model A Tires

I was told that Bert’s carry exactly the same tubes!


www.modelastore.com
Forum: Model A (1928-31) 10-07-2020, 10:43 PM
Replies: 26
Views: 1,265
Posted By Benson
Re: Annoying ads

correction
Forum: Model A (1928-31) 10-06-2020, 12:34 PM
Replies: 24
Views: 1,568
Posted By Benson
Forum: Model A (1928-31) 10-03-2020, 06:19 PM
Replies: 7
Views: 443
Posted By Benson
Forum: Model A (1928-31) 10-03-2020, 04:47 PM
Replies: 8
Views: 403
Posted By Benson
Re: Camera Recommendations for Recording Model A Suspension

One suggestion about cameras is the microphone.

If the camera will be anywhere outside the car personally it makes a much more enjoyable video if the microphone is NOT located in the slipstream....
Forum: Model A (1928-31) 10-02-2020, 06:05 PM
Replies: 26
Views: 1,257
Posted By Benson
Forum: Model A (1928-31) 10-02-2020, 09:29 AM
Replies: 11
Views: 2,667
Posted By Benson
Re: Weber carb

Denis,

See red above:
Since they replaced the fuel fitting ... are you running without a fuel pump?

I heard that these Webbers run lean when fuel tank gets down to 3/4 full if running gravity...
Forum: Model A (1928-31) 10-02-2020, 08:03 AM
Replies: 26
Views: 1,257
Posted By Benson
Re: throw-out bearing

Maybe the idiots are making BOGUS Timken and Federal Mogul/National boxes?
Forum: Model A (1928-31) 10-01-2020, 03:02 PM
Replies: 21
Views: 857
Posted By Benson
Forum: Model A (1928-31) 10-01-2020, 12:08 PM
Replies: 11
Views: 573
Posted By Benson
Re: Radius Ball Service

The offshore people who made the rubber balls in the 60s 70s and 80s were most likely using the same rubber that they later used to make the inner tubes of 10 -15 years ago and some of us know how...
Forum: Model A (1928-31) 10-01-2020, 11:52 AM
Replies: 11
Views: 573
Posted By Benson
Re: Radius Ball Service

Because in the thirties they had real rubber which lasted much longer when soaked in oil.

All I know is that the ones I tried in the 60's turned to mush in short order.

And all of the...
Forum: Model A (1928-31) 10-01-2020, 10:15 AM
Replies: 11
Views: 573
Posted By Benson
Forum: Model A (1928-31) 09-29-2020, 02:06 PM
Replies: 190
Views: 37,421
Posted By Benson
Re: The Terry Burtz 5 main bearing engine blocks are back on track.

I also was surprised to see the low oil pressure.

The 3/8ths plug missing explains why.

We had just the opposite problem.

We built a full pressure, drilled B block in 1976 with oil system...
Forum: Model A (1928-31) 09-29-2020, 10:31 AM
Replies: 13
Views: 1,010
Posted By Benson
Re: Bert's number not working?

I just tested the 1-800 321-1931 number it works fine...
Forum: Model A (1928-31) 09-29-2020, 07:29 AM
Replies: 8
Views: 336
Posted By Benson
Re: B Carb Exploded view

Post 6 is a diagram of the early V8 carb made by Detroit Lubricator.
Forum: Model A (1928-31) 09-25-2020, 10:10 AM
Replies: 12
Views: 976
Posted By Benson
Re: Zenith 2405N replacement carburetor

xin lỗi ... Wrong info
Forum: Model A (1928-31) 09-18-2020, 06:01 AM
Replies: 30
Views: 1,255
Posted By Benson
Re: Wheel interchange

Service Bulletin page 328 says that B style wheels should NEVER be installed on AR hubs as they donot fit correctly and doing so is dangerous and will result in cracked wheels with possible wheel...
Forum: Model A (1928-31) 09-17-2020, 09:34 AM
Replies: 32
Views: 1,321
Posted By Benson
Forum: Model A (1928-31) 09-16-2020, 04:23 PM
Replies: 18
Views: 792
Posted By Benson
Re: Radius ball cap

FYI:

There several different ways to replace the ball.

Find out how it will be done BEFORE you cut the wishbone!

1. One cuts the ball off like in post 13 above showing the photo above.

...
Forum: Model A (1928-31) 09-16-2020, 08:48 AM
Replies: 18
Views: 792
Posted By Benson
Re: Radius ball cap

There are two types as mentioned:

1. The original Repro in Berts catalog A-3440 RADIUS CAP SET - ORIGINAL STYLE

2. The rubber ball type

The catalog photo will tell you which type that...
Forum: Model A (1928-31) 09-11-2020, 02:45 PM
Replies: 92
Views: 32,865
Posted By Benson
Re: Lion Speed Head

DB,

I was visiting SteveB31 the other day and that head on his car is indeed a Lion Head III
Forum: Model A (1928-31) 09-11-2020, 05:20 AM
Replies: 10
Views: 447
Posted By Benson
Where to find Ethanol free gasoline in your area

Where to find Ethanol free gasoline in your area:



https://www.pure-gas.org/


1. Select "state".

2. Be sure to read "Details" column on right.
Forum: Model A (1928-31) 09-02-2020, 04:50 PM
Replies: 6
Views: 455
Posted By Benson
Re: Lug Nuts

I do not know if people check but Vince Falter has a webpage on the subject.

http://www.fordgarage.com/pages/dangerouslugnuts.htm
Forum: Model A (1928-31) 08-31-2020, 02:46 PM
Replies: 21
Views: 1,080
Posted By Benson
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 12:35 AM.