Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 65
Search took 0.01 seconds.
Search: Posts Made By: unclevinny
Forum: Late V8 (1954+) 08-25-2021, 08:42 AM
Replies: 6
Views: 612
Posted By unclevinny
Re: 1958 ranchero fuel gage prolem

Thank you for responding to my gage problem I have tested the CVR that cost me 71 dollars and the output side responds in the fashion with the voltage going from 5 1/2 volts down to 2 volts and then...
Forum: Late V8 (1954+) 08-22-2021, 11:26 AM
Replies: 6
Views: 612
Posted By unclevinny
1958 ranchero fuel gage prolem

new sending unit, new napa rin1 CVR new wire from sender to gage when i turn the ignition on the gage goes to full [tank is full] but then drops to 1/4 and then rises to over half and repeats this...
Forum: Late V8 (1954+) 07-28-2021, 04:35 PM
Replies: 7
Views: 571
Posted By unclevinny
58 ford 332 fe runs with battery disconneted

what is wrong in my starter/electric system to allow the engine to remain running with batter competly disconnected it will kill with the key battery cables seem to be too warm too
Forum: Late V8 (1954+) 12-07-2020, 11:39 AM
Replies: 5
Views: 481
Posted By unclevinny
Re: '56 332 Ford FE water pump leak

I am releived to get that info!! i am 75 years old and worked on ford engines alot but never experienced this leak nor did i ever know that water jacket is that way I learn something every day i...
Forum: Late V8 (1954+) 12-07-2020, 10:08 AM
Replies: 5
Views: 481
Posted By unclevinny
Re: '56 332 Ford FE water pump leak

I might have done a typo the engine is a 58 and yes it is the lower passenger side mount bolt
Forum: Late V8 (1954+) 12-06-2020, 12:08 PM
Replies: 5
Views: 481
Posted By unclevinny
'56 332 Ford FE water pump leak

Water leak between pump and block lower mount bolt. Took the pomp off and found a bad gasket, and that particular bolt is the same length as the other 3 as i did measure them before i installed the...
Forum: Early V8 07-27-2020, 07:27 AM
Replies: 0
Views: 176
Posted By unclevinny
9 inch diffys T85 tranny edsel parts

The diffys are 3.10 and 3.25 $200 ea. the T 85 B/W tranny with R11 O/D works great needs a input shaft retainer and speedometer gear and O/D selinode asking $400 Also have some '58 and '59...
Forum: Late V8 (1954+) 03-08-2020, 05:18 PM
Replies: 15
Views: 1,383
Posted By unclevinny
Re: three on the tree shifting rods

I received my correct p/n in the mail 2 days after i called that Ford dealer Wow!!! perfect fit and I put them in maybe 20 min total and the sloppy connection is gone!! ANDDD i went ahead and...
Forum: Late V8 (1954+) 03-04-2020, 12:50 PM
Replies: 15
Views: 1,383
Posted By unclevinny
Re: three on the tree shifting rods

well alll i can say is that they not at a big loss because of me i don't think I will need them for anyting again anyhow!
Forum: Late V8 (1954+) 03-03-2020, 05:32 PM
Replies: 15
Views: 1,383
Posted By unclevinny
Re: three on the tree shifting rods

I appreciate all the help i talked to mac and the tech there said that the on they would not fit and hung up I found a ford dealer that gave me a number for a dearlership in New Jersey And after...
Forum: Late V8 (1954+) 03-03-2020, 10:46 AM
Replies: 15
Views: 1,383
Posted By unclevinny
three on the tree shifting rods

I cant find any source to get the shift rod bushings for my '58 ford Ranchero. Anyone know a vendor or part nimber for these? thanks
Forum: Late V8 (1954+) 02-12-2020, 01:07 PM
Replies: 8
Views: 1,135
Posted By unclevinny
Re: Car Show Yesterday

I went to several car shows mostly to see the nice work that is done on preserving the older cars. I did enter a small town car show once was put on by the local car club there and /the officrs of...
Forum: Late V8 (1954+) 11-08-2019, 12:37 PM
Replies: 9
Views: 1,212
Posted By unclevinny
Re: rebuild T85 tranny

I will get ahold of Mac I have had great results with him on a t 86. i understand the r11 oil skaring with the t 85 main case but i am not sure if i can improve the input shaft bearing with a...
Forum: Late V8 (1954+) 11-06-2019, 05:50 PM
Replies: 9
Views: 1,212
Posted By unclevinny
Re: rebuild T85 tranny

Yes i refered to 7065 and i do have a new7A283 so i feel that is is the correct application however i think that bearing is a bit too sloppy and should be replaced I had heard that the new and...
Forum: Late V8 (1954+) 11-06-2019, 02:56 PM
Replies: 9
Views: 1,212
Posted By unclevinny
rebuild T85 tranny

I am rebuilding my T85 and interested in replacing the input shaft flow thru bearing with a sealed bearing. However if it aint in the computer the parts man claims it is not available. Does anybody...
Forum: Late V8 (1954+) 06-27-2019, 04:32 PM
Replies: 13
Views: 1,318
Posted By unclevinny
Re: 3 on the tree t56 gear box r10 0d problem

Thanks rotowrence i am almost sure it has to be in that overdrive rail something isnt fitted up quite right I know that it is getting a good grip on reverse so the slidergear is engaging in low and...
Forum: Late V8 (1954+) 06-26-2019, 03:45 PM
Replies: 13
Views: 1,318
Posted By unclevinny
Re: 3 on the tree t56 gear box r10 0d problem

I read your tranny experience and liked the complete story i also have found Mac VanPelt as the place to do honest business Mac bailed me out with a new tail shaft bushing [perfect fit too] and...
Forum: Late V8 (1954+) 06-26-2019, 02:09 PM
Replies: 13
Views: 1,318
Posted By unclevinny
Re: 3 on the tree t56 gear box r10 0d problem

thanks for the come back on probable cause. Happy Travels!
Forum: Late V8 (1954+) 06-26-2019, 02:07 PM
Replies: 13
Views: 1,318
Posted By unclevinny
Re: 3 on the tree t56 gear box r10 0d problem

I was trying to not believe exactly the same thing as the shift rail being somewhat bonkers, as you know what has to happen now oh well i will pull it back out and getter opened up again lol lol...
Forum: Late V8 (1954+) 06-26-2019, 11:26 AM
Replies: 13
Views: 1,318
Posted By unclevinny
Re: 3 on the tree t56 gear box r10 0d problem

maybe hang a for sale sign on it lol??
Forum: Late V8 (1954+) 06-26-2019, 11:25 AM
Replies: 13
Views: 1,318
Posted By unclevinny
Re: 3 on the tree t56 gear box r10 0d problem

yes i start it and try it with the linkage off and manually shift it with just the tranny lever i try it with linkage hooked up and all the same results reverse if off the floor but not when i...
Forum: Late V8 (1954+) 06-25-2019, 05:26 PM
Replies: 0
Views: 566
Posted By unclevinny
Cool 3 on the tree t86 gear box r10 0d problem

I have a good easy shift pattern and on blocks everything goes well but when i put it on the floor there is no reverse
What have i done wrong???
Forum: Late V8 (1954+) 06-25-2019, 05:24 PM
Replies: 13
Views: 1,318
Posted By unclevinny
Forum: Late V8 (1954+) 06-25-2019, 05:22 PM
Replies: 13
Views: 1,318
Posted By unclevinny
Cool 3 on the tree t56 gear box r10 0d problem

I have a good easy shift pattern and on blocks everything goes well but when i put it on the floor there is no reverse
What have i done wrong???
Forum: Late V8 (1954+) 05-27-2019, 02:57 PM
Replies: 4
Views: 785
Posted By unclevinny
9 inch ford swaps

I have ford nine inch 3.70 ratio in my 58 ranchero but they show lots of wear especially on pnion teeth so now I also have a 9 inch 3.25s out of a 65 ford f 100 and looks really good shape ...
Showing results 1 to 25 of 65

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 05:28 PM.