Forum: Model A (1928-31)
05-25-2021, 04:57 AM
|
Replies: 347
Views: 202,779
|
Forum: Model A (1928-31)
05-24-2021, 04:56 AM
|
Replies: 347
Views: 202,779
|
Forum: Model A (1928-31)
05-23-2021, 07:20 PM
|
Replies: 347
Views: 202,779
Re: F150 tranny with overdrive
I am trying to remove the tower on my OD trans, and wondered dose the trans need to be in any particular gear to take the tower off? I have it in neutral , but cant get the forks to clear. thanks.
|
Forum: Model-A
04-03-2020, 10:21 AM
|
Replies: 0
Views: 1,090
early 1930 fordor sedan for sale
. I have an April 1930 Murray Fordor sedan. It was restored in the mid seventies. Engine runs well a compression test shows 70 on each cylinder. Interior is in good condition with a few small holes,...
|
Forum: Model-A
11-14-2019, 06:08 AM
|
Replies: 1
Views: 1,284
|
Forum: Model A (1928-31)
10-06-2019, 06:33 AM
|
Replies: 6
Views: 1,608
Re: Door sill numbers
Thanks Dave and Brent, I am bringing the car out to sell at Hershey. I love knowing the history of the car when people ask about it. This on still has the original horn and wiper with it. Thanks...
|
Forum: Model A (1928-31)
10-05-2019, 04:06 PM
|
Replies: 6
Views: 1,608
Door sill numbers
I found the initials NK686 stamped into the wood sill of a 1930 Fordor sedan.Is there a list of the factory initials that would tell me where this car was built? Thanks
|
Forum: Model-A
09-30-2019, 07:52 PM
|
Replies: 1
Views: 1,284
early 1930 fordor sedan for sale
I have a April 1930 Murray Fordor sedan. It was restored in the mid seventies. Engine runs well a compression test shows 70 on each cylinder. Interior is in good condition with a few small holes,...
|
Forum: Model A (1928-31)
09-26-2019, 05:27 AM
|
Replies: 32
Views: 5,482
|
Forum: Model A (1928-31)
10-07-2018, 07:30 AM
|
Replies: 29
Views: 7,643
|
Forum: Model A (1928-31)
10-05-2018, 05:23 AM
|
Replies: 31
Views: 7,448
Re: Tight engine
Be prepared for a lot of smoke from the oil being put in the cylinders. I started an engine that had sat in a container for 25 years, my friend had poured oil down the cylinders once a year. When we...
|
Forum: Model A (1928-31)
08-24-2018, 05:28 AM
|
Replies: 5
Views: 1,396
|
Forum: Model A (1928-31)
08-20-2018, 04:16 PM
|
Replies: 2
Views: 1,311
|
Forum: Model A (1928-31)
08-20-2018, 05:58 AM
|
Replies: 9
Views: 2,154
Re: Gas peddle & footrest escutcheon 's
I thought the gas pedal had a rubber seal nailed to the floor board with 3 tacks? What dose the escutcheon look like? Or are you talking about the foot rest base?
|
Forum: Model A (1928-31)
08-19-2018, 05:25 AM
|
Replies: 39
Views: 7,021
Re: Temperature Rises after shutdown
I agree with Eagle, when you flushed the engine it caused rust and other garbage to loosen up. I recently took a car for a ride that had been sitting for a while and had the same problem. The top...
|
Forum: Model A (1928-31)
08-16-2018, 12:40 PM
|
Replies: 2
Views: 1,311
|
Forum: Model A (1928-31)
08-07-2018, 05:40 PM
|
Replies: 5
Views: 2,983
|
Forum: Model A (1928-31)
06-21-2018, 05:19 AM
|
Replies: 7
Views: 2,156
Re: branson
We are leaving tomorrow morning. Two town sedans and the bus. 1,150 miles in 4 days, oh boy. We all have overdrives.
|
Forum: Model A (1928-31)
06-21-2018, 05:15 AM
|
Replies: 16
Views: 4,491
|
Forum: Model A (1928-31)
06-20-2018, 05:30 AM
|
Replies: 19
Views: 3,763
|
Forum: Model A (1928-31)
06-20-2018, 05:06 AM
|
Replies: 16
Views: 4,491
Re: 160 B front door window trim
Well more investigation and thanks to Vince Faller, I think the problem is solved. I believe my friend is missing the glass run retainer. http://www.fordgarage.com/pages/murraybriggs.htm
I need...
|
Forum: Model A (1928-31)
06-16-2018, 06:13 AM
|
Replies: 16
Views: 4,491
Re: 160 B front door window trim
Some further investigation reveals that my friends car is not a thoroughbred Briggs. The cowl was replaced with a Murray cowl and maybe Murray doors. The cowl has caged nuts across the bottom of the...
|
Forum: Model A (1928-31)
06-15-2018, 05:16 AM
|
Replies: 16
Views: 4,491
|
Forum: Model A (1928-31)
06-13-2018, 05:50 AM
|
Replies: 16
Views: 4,491
Re: 160 B front door window trim
Thanks B, your frames match my early Briggs frames. Anyone able to post a picture of a late 160B frame?
Where did you find the assembly plant I.D. on your car?
|
Forum: Model A (1928-31)
06-12-2018, 07:50 PM
|
Replies: 16
Views: 4,491
|