Forum: Early V8 (1932-53)
01-09-2016, 03:17 PM
|
Replies: 27
Views: 5,709
Re: What State
CSArno,
That would be correct except Lakeview is at the south end of Schoodic.
|
Forum: Early V8 (1932-53)
01-07-2016, 03:27 PM
|
Replies: 27
Views: 5,709
Re: What State
CSArno,
The 1st time I was through DF was mid 50's and I don't recall seeing you. I may have seen your pickup though with slightly less cancer. Family bounced around the area in the 1880's and...
|
Forum: Early V8 (1932-53)
08-30-2015, 01:30 PM
|
Replies: 9
Views: 1,741
|
Forum: Early V8 (1932-53)
07-26-2015, 02:38 PM
|
Replies: 30
Views: 7,661
Re: fuel mileage ?
37 tudor all original, 3.78 rear, 60-65 on hwy. 20 mpg. Around town about 10 mpg.
|
Forum: Early V8 (1932-53)
04-26-2015, 05:03 PM
|
Replies: 7
Views: 1,769
|
Forum: Early V8 (1932-53)
04-25-2015, 03:14 PM
|
Replies: 22
Views: 4,752
|
Forum: Early V8 (1932-53)
04-24-2015, 03:35 PM
|
Replies: 4
Views: 1,310
Re: Relining Brake Shoes
Any brake shop that caters to commercial trucks can bond woven linings to your shoes. I've had bonded woven shoes on a 37 for 5 years and wouldn't even think of having rivets due to lack of...
|
Forum: Early V8 (1932-53)
04-22-2015, 03:48 PM
|
Replies: 3
Views: 1,492
|
Forum: Early V8 (1932-53)
04-04-2015, 02:40 PM
|
Replies: 10
Views: 2,812
|
Forum: Early V8 (1932-53)
03-14-2015, 04:03 PM
|
Replies: 18
Views: 3,332
Re: 6 volt tach
This is from normal sitting position in a 37. Hose clamp and a piece of inner tube for a cushy. Piece of cake to install.
|
Forum: Early V8 (1932-53)
03-05-2015, 03:17 PM
|
Replies: 17
Views: 2,859
Re: Tubeless Tires
I've been running tubeless radials on a 37 for 4 years and have had no problems. The only way to roll.
|
Forum: Early V8 (1932-53)
11-25-2014, 04:16 PM
|
Replies: 28
Views: 4,922
Re: Dilemma
If you have no knocks ask yourself how many quarts of oil can I buy for $3000-4000. Use MMO it does work.
trulyvintage: It's liquid sunshine.
|
Forum: Early V8 (1932-53)
10-20-2014, 03:05 PM
|
Replies: 15
Views: 3,384
|
Forum: Early V8 (1932-53)
07-22-2014, 04:01 PM
|
Replies: 14
Views: 3,912
|
Forum: Early V8 (1932-53)
02-28-2014, 03:14 PM
|
Replies: 4
Views: 1,696
|
Forum: Early V8 (1932-53)
02-06-2014, 05:46 PM
|
Replies: 8
Views: 1,609
|
Forum: Early V8 (1932-53)
10-23-2013, 03:09 PM
|
Replies: 3
Views: 1,142
Re: 1937 Tudor door seals
I ran Mac's seals from front bottom of door to the B pillar. Door originally had a flat seal from top hinge to bottom of door. Perhaps one of the earlier or later seals will fit the door. However the...
|
Forum: Early V8 (1932-53)
10-06-2013, 12:30 AM
|
Replies: 385
Views: 89,982
|
Forum: Early V8 (1932-53)
10-01-2013, 02:00 PM
|
Replies: 16
Views: 9,133
Re: winshield rubber seal install 1934
I've used linseed oil. Stays in liquid state for a day or so and can be cleaned up with generic paint thinner which won't harm the paint. Apply to groove area with q-tip or small artist brush and...
|
Forum: Early V8 (1932-53)
09-17-2013, 09:31 PM
|
Replies: 1
Views: 961
Re: 37 Tudor subrail Question
No. The backer panel when the upholstery is on should be about 1/8th off the floor pan. If I'm reading the photo correctly.
Gary
|
Forum: Early V8 (1932-53)
09-15-2013, 12:21 PM
|
Replies: 4
Views: 1,724
Re: Run To Vantage, Wa tomorrow
Probably east. When I signed the sheet I was top of 3rd page with about 17 per page and that was at noon. Someone later said it was 2 to 1 favoring the east.
Gary
|
Forum: Early V8 (1932-53)
08-14-2013, 10:14 PM
|
Replies: 9
Views: 1,641
|
Forum: Early V8 (1932-53)
08-10-2013, 11:48 PM
|
Replies: 2
Views: 1,081
Re: Relining Brakes 36
Go with the woven, have them bonded to the shoes and leading edge relieved. You will be able to stop on a dime and leave change.
|
Forum: Early V8 (1932-53)
06-15-2013, 06:01 PM
|
Replies: 9
Views: 3,778
|