Go Back   The Ford Barn > Search Forums
Reload this Page Search Results

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 4 of 4
Search took 0.00 seconds. Search: Posts Made By: Kube
Forum: Early V8 (1932-53) 10-07-2021, 07:04 PM
Replies: 19
Views: 2,095
Posted By Kube
Re: Removing the Flywheel

Your flywheel most certainly needs to be resurfaced.
Removing the engine in your car is approximately a two to three hour task at most. This was hardly a huge burden upon the owner "back in the...
Forum: Early V8 (1932-53) 10-07-2021, 06:09 PM
Replies: 19
Views: 2,095
Posted By Kube
Re: Removing the Flywheel

You MUST remove the pan. You will not be able to get the flywheel assembly out of the opening without the pan being removed.

1/16" at a time is about right.

Now go remove the pan...
Forum: Early V8 (1932-53) 10-07-2021, 12:07 PM
Replies: 19
Views: 2,095
Posted By Kube
Re: Removing the Flywheel

The pilot bearing is integral of the flywheel. I prefer a shielded bearing vs. a bronze bushing.
It's a simple R&R without any special pullers, etc.
Forum: Early V8 (1932-53) 10-06-2021, 06:36 PM
Replies: 19
Views: 2,095
Posted By Kube
Re: Removing the Flywheel

If you've removed the four bolts, it is simply stuck. Large hammer with a block of wood... tap a little on one side, then 180° from that.
Showing results 1 to 4 of 4

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 05:11 AM.