Forum: Model A (1928-31)
01-10-2021, 10:56 AM
|
|
Replies: 21
Views: 971
|
|
Forum: Model A (1928-31)
12-27-2020, 10:06 AM
|
|
Replies: 28
Views: 1,498
|
|
Forum: Model A (1928-31)
12-22-2020, 12:20 PM
|
|
Replies: 12
Views: 1,281
|
|
Forum: Model A (1928-31)
12-14-2020, 02:34 PM
|
|
Replies: 25
Views: 1,024
Re: Coil or condenser over heat
i tried one of the heat shields and wasn't that much impressed . Needing to loosen two head nuts to install the shield didn't seem to be the best idea . Loosening head nuts runs the risk of losing...
|
|
Forum: Model A (1928-31)
12-08-2020, 10:29 AM
|
|
Replies: 12
Views: 816
|
|
Forum: Model A (1928-31)
12-05-2020, 11:06 PM
|
|
Replies: 7
Views: 408
Re: 12 volt system on a Model A
With a three OHM coil the ignition will also operate on 12 volt . If a resistor and six volt coil are used , the ignition will be running on a weaker six volts and won't run as well .
|
|
Forum: Model A (1928-31)
12-05-2020, 10:52 PM
|
|
Replies: 7
Views: 408
|
|
Forum: Model A (1928-31)
12-05-2020, 10:43 PM
|
|
Replies: 10
Views: 489
Re: Generator question
Shims are offered to remove end play in the armature shaft , I think that Bratton offers them . I used them when I overhauled my generators and starters .
|
|
Forum: Model A (1928-31)
12-05-2020, 09:54 AM
|
|
Replies: 26
Views: 1,376
|
|
Forum: Model A (1928-31)
12-04-2020, 06:49 PM
|
|
Replies: 6
Views: 803
Re: Trojan plug
I've got a dual updraft Trojan intake manifold on my roadster .
|
|
Forum: Model A (1928-31)
12-04-2020, 01:30 PM
|
|
Replies: 26
Views: 1,376
Re: Conversion to 12 volt system
Just to add , I use the original style 20 amp ammeter with the 12 volt conversion on my model A and have for many years with no problem .
|
|
Forum: Model A (1928-31)
12-03-2020, 01:18 PM
|
|
Replies: 26
Views: 1,376
Re: Conversion to 12 volt system
Converting to twelve volts is a VERY SIMPLE procedure . I allow mine to remain positive ground and no wires need to be changed or swapped . The original style wiring system uses large gauge wire...
|
|
Forum: Model A (1928-31)
12-01-2020, 10:29 AM
|
|
Replies: 20
Views: 1,287
|
|
Forum: Model A (1928-31)
11-29-2020, 10:44 AM
|
|
Replies: 8
Views: 664
|
|
Forum: Model A (1928-31)
11-26-2020, 09:07 AM
|
|
Replies: 91
Views: 6,319
Re: 16" Wheels
In my opinion, sixteen inch wheels ruin the original look of the model A .
|
|
Forum: Model A (1928-31)
11-25-2020, 06:27 PM
|
|
Replies: 15
Views: 861
|
|
Forum: Model A (1928-31)
11-25-2020, 10:58 AM
|
|
Replies: 48
Views: 3,285
|
|
Forum: Model A (1928-31)
11-24-2020, 10:21 PM
|
|
Replies: 15
Views: 861
|
|
Forum: Model A (1928-31)
11-24-2020, 10:28 AM
|
|
Replies: 6
Views: 677
|
|
Forum: Model A (1928-31)
11-24-2020, 10:24 AM
|
|
Replies: 15
Views: 861
Re: Condenser mount
I mount the condenser on the switch side of the coil on some of my model A's . This will be the side of the coil that uses the red wire if the wiring is original style . This isn't necessarily more...
|
|
Forum: Model A (1928-31)
11-23-2020, 01:33 PM
|
|
Replies: 73
Views: 5,257
Re: Bone Stock or Modified?
I mostly use modifications that don't show or stand out as modifications . I run a stock appearing higher compression head that gives more power for hills . I seldom drive the model A over 50 mph ....
|
|
Forum: Model A (1928-31)
11-20-2020, 08:17 PM
|
|
Replies: 33
Views: 1,791
|
|
Forum: Model A (1928-31)
11-14-2020, 08:54 AM
|
|
Replies: 16
Views: 1,011
Re: Steering wheel paint
I used bondo and it filled the cracks and gaps nicely .. After a fairly short time it became obvious that cracks had been repaired .
|
|
Forum: Model A (1928-31)
11-13-2020, 11:41 AM
|
|
Replies: 16
Views: 1,011
Re: Steering wheel paint
I've had decent luck with acrylic lacquer . The cracks eventually come back , no matter what I use for a filler . For a good job , I've found it best to go ahead and replace the steering wheel with a...
|
|
Forum: Model A (1928-31)
11-11-2020, 03:29 PM
|
|
Replies: 12
Views: 587
Re: Radiator Paint
I avoid heavy paint build up on the radiator . Paint will insulate . I try to just barely cover the radiator with semi gloss black paint . Type or shade of black is a matter of choice , I guess .
|
