Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 390
Search took 0.02 seconds.
Search: Posts Made By: emf
Forum: Model-A 01-07-2021, 03:35 PM
Replies: 0
Views: 150
Posted By emf
For Sale - Mallory Distributor

Nice Mallory distributor for the Model A, plus extra rotor and wire. 518-755-0986. Shipping extra. US only.
Forum: Model-A 11-13-2020, 10:51 AM
Replies: 0
Views: 249
Posted By emf
Mallory Distributor FS

Nice Mallory distributor for sale with extra rotor and harness. Mallory PN 2301105H. Clean and in excellent condition. $300. 518-755-0986.
Forum: Model-A 09-18-2020, 01:40 PM
Replies: 0
Views: 189
Posted By emf
Model B Cylinder Head / Water Pump FS

Good used Model B cylinder head: $120, good used water pump: $75, No paypal, checks OK US sales only. 518-755-0986


Frank
Forum: Model-A 09-18-2020, 01:37 PM
Replies: 0
Views: 121
Posted By emf
Model B Exhaust Manifold FS

One good used Model B exhaust manifold for sale. US sales only. No paypal, checks OK. 518-755-0986


Frank
Forum: Model A (1928-31) 08-29-2020, 07:44 AM
Replies: 4
Views: 514
Posted By emf
Re: Mechanical fuel pump

If you are running an updraft carburetor, nix the pump. If a downdraft, you'll need it. If updraft, keep it for now, in case you change your mind...


Frank
Forum: Model A (1928-31) 06-30-2020, 11:40 AM
Replies: 42
Views: 2,159
Posted By emf
Re: Any electronic experts out there

I have some experience... Worked for 30 yeas as an electronics engineer. Not sure if a core placed on the coil wire would work, since the high energy bursts are also picked up by the bare copper...
Forum: Model A (1928-31) 06-30-2020, 07:32 AM
Replies: 42
Views: 2,159
Posted By emf
Re: Any electronic experts out there

Every time a switch (in this case, a set of points) opens and closes, RF noise is generated. Add that to the original, uninsulated, unshielded copper spark plug wires and you have an antenna emitting...
Forum: Model A (1928-31) 05-23-2020, 07:41 AM
Replies: 19
Views: 1,195
Posted By emf
Re: Modern distributor cap

Quite a bit of difference. With the modern cap the engine won't misfire when it gets wet, modern wires won't emit huge amounts of RFI when the car is running.



Frank
Forum: Model A (1928-31) 04-29-2020, 07:16 AM
Replies: 20
Views: 1,647
Posted By emf
Re: Headlight resilver or repalace

The "fella in Ore" is most likely Uvira. Google it. They electroplate aluminum onto the reflector and polish it. I had it done on my old Graham MANY years ago and the brightness approached a sealed...
Forum: Late V8 (1954+) 03-27-2020, 05:37 PM
Replies: 10
Views: 834
Posted By emf
Re: Wanted-Good 55-56 Ford Station Wagon/Courrier Gas Tank

I've bought from them many times and have always been satisfied. The only issue I have with that tank is that the original sender cannot be used. Not sure why, but maybe this is a universal tank with...
Forum: Late V8 (1954+) 03-27-2020, 03:50 PM
Replies: 10
Views: 834
Posted By emf
Re: Wanted-Good 55-56 Ford Station Wagon/Courrier Gas Tank

I, too am looking for a gas tank. Maybe it's something in the air... I need this for a 54 Crestline. Auto City Classic's on-line catalog doesn't have it and neither does Spectra (could not find...
Forum: Model A (1928-31) 02-11-2020, 04:59 PM
Replies: 12
Views: 891
Posted By emf
Re: AA Transmission Replacement

It doesn't get much easier than the Mitchell. I installed a 36% unit in my 28 AA in less than a day's work. Raised on the lift, dropped the torque tube, installed the Mitchell, drove it away. The...
Forum: Model A (1928-31) 02-07-2020, 04:03 PM
Replies: 28
Views: 2,749
Posted By emf
Re: “Do not use a file” to dress down breaker points

Not sure I would use emery paper anywhere electrons are flowing. (points, armatures, etc) Emery is conductive and may short out to ground if grit accumulates. Sand paper would be a better choice if a...
Forum: Model A (1928-31) 01-11-2020, 09:07 AM
Replies: 25
Views: 1,796
Posted By emf
Re: "B" Distributor timing with an "A" front cover

I believe the initial timing on the engine is set by the timing cover. When the pin drops into the hole with the A cover, the initial timing is at TDC. The B cover advances this initial timing by 19*...
Forum: Model A (1928-31) 12-30-2019, 06:12 PM
Replies: 36
Views: 3,189
Posted By emf
Re: Over Drive

Thanks for the compliment. I asked about the input shaft, since the worm drive has a 10 spline shaft on the input. If yours is the same, there would be no change to attach. However, it might be a...
Forum: Model A (1928-31) 12-30-2019, 08:05 AM
Replies: 36
Views: 3,189
Posted By emf
Re: Over Drive

I missed that you have a ring & pinion rear. Mine is the worm drive with 5:1 gears. Does yours have the 10 spline input shaft? If so, it may be the same as mine. Mitchell would know...


Frank
Forum: Late V8 (1954+) 12-29-2019, 11:30 AM
Replies: 29
Views: 3,611
Posted By emf
Re: 292 Y Block Electronic Ignition Conversion Advice

I'm still running 6 volts in my '54 with the 239. For better headlights, I installed the 12 volt LED's from Rodtiques, using their 12v inverter module. Why couldn't I run a 12 volt feed to the Accel...
Forum: Model A (1928-31) 12-29-2019, 11:08 AM
Replies: 36
Views: 3,189
Posted By emf
Re: Over Drive

I installed a 36% Mitchell in my 1928 AA firetruck and have had amazing results. Before the Mitchell, I could not do more than 20 mph without the engine screaming. Now 40-45 mph is easily obtained...
Forum: Model-T 10-20-2019, 07:31 AM
Replies: 0
Views: 843
Posted By emf
Red Hook Restorations

The post below cannot be replied to:


Does anyone have any information regarding Red Hook Restorations in Hudson NY.
I sent them money for T Bands andd never received them. emf from Red Hook...
Forum: Model A (1928-31) 10-18-2019, 07:25 AM
Replies: 20
Views: 1,763
Posted By emf
Re: Any AA trucks running 55mph?

I have a 1928 AA with the original 3 speed transmission and a Mitchell gear splitter (36% over) and I can do 45 mph all day long without having the engine screaming. Very happy with it and I did not...
Forum: Model A (1928-31) 09-30-2019, 11:28 AM
Replies: 3
Views: 749
Posted By emf
Re: New Radiator from ebay

Here is a photo taken from ebay. The Berg radiator with 10 fins per inch is priced at $795. This one on ebay has 9 fins per inch and is priced at $585 with $35 for shipping.....


...
Forum: Model A (1928-31) 09-29-2019, 06:39 PM
Replies: 3
Views: 749
Posted By emf
New Radiator from ebay

I just found an ebay seller: benderb426 from Crystal Lake, Ill that sells a new radiator with 3 rows, 9 fins per inch for $585 plus shipping. I sent a note and he makes them himself, so they are US...
Forum: Late V8 09-21-2019, 09:53 AM
Replies: 0
Views: 460
Posted By emf
1954 Mercury Engine Police Special F/S

Up for sale is a 1954 Mercury Police Special short block. Totally rebuilt: magnafluxed, tank cleaned. Pistons, bearings, valves, valve springs, lifters, etc. all done. Crank: -.040; Rods: -.010;...
Forum: Model-A 09-19-2019, 07:35 AM
Replies: 0
Views: 295
Posted By emf
Model B Fuel Pump

Correct Model B fuel pump, professionally cleaned and rebuilt for modern fuel. $325. Free shipping to lower 48. Delivery to Hershey also. 518-755-0986


Frank
Forum: Early V8 09-19-2019, 07:32 AM
Replies: 0
Views: 241
Posted By emf
Flathead 60 Parts

I have a pair of exhaust manifolds, intake manifold, pair of cylinder heads. Delivery to Hershey. 518-755-0986


Frank
Showing results 1 to 25 of 390

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 01:22 PM.