Forum: Model A (1928-31)
12-21-2018, 02:32 PM
|
Replies: 4
Views: 1,329
Re: distributor bushings
This repair is for 31 Plymouth PA equipped with a Delco Remy 629 H
distributor. Pretty sure parts are not available.
|
Forum: Model A (1928-31)
12-21-2018, 11:46 AM
|
Replies: 4
Views: 1,329
distributor bushings
I need to re bush the distributor shaft (not Model A)
will likely need to turn down an oversize bushing. Are there any specific types of brass bushing best suited for this ...oil lite or ??
Dave
|
Forum: Model A (1928-31)
11-06-2018, 11:18 PM
|
Replies: 3
Views: 1,370
bulb change
So what is the trick to get the cowl lights apart 30 coupe? Time to replace the bulbs
|
Forum: Model A (1928-31)
07-20-2018, 02:17 PM
|
Replies: 2
Views: 1,350
Identify this switch
Switch is marked Ford on the rear side, has terminals for head lights, side and tail lights. But no magneto terminal.
|
Forum: Model A (1928-31)
02-24-2018, 05:36 PM
|
Replies: 88
Views: 41,701
|
Forum: Model A (1928-31)
06-09-2017, 03:15 PM
|
Replies: 6
Views: 1,059
|
Forum: Model A (1928-31)
06-09-2017, 10:16 AM
|
Replies: 6
Views: 1,059
Erratic ammeter (not Model A)
I have a 31 Plymouth that has an issue with the amp gauge. At an idle it behaves fine, once the engine is up to operating speed the needle swings back and forth from charge, about 8 -10 amps down to...
|
Forum: Model A (1928-31)
06-07-2017, 05:51 PM
|
Replies: 13
Views: 3,047
|
Forum: Model A (1928-31)
03-24-2017, 10:30 AM
|
Replies: 9
Views: 1,915
Re: ignition switch repair
Haven't installed it yet but it seems to work fine. The issue was it had no continuity between the switch and the distributo./r The switch housing is a die cast type, in order to remove the back I...
|
Forum: Model A (1928-31)
03-22-2017, 10:27 PM
|
Replies: 9
Views: 1,915
|
Forum: Model A (1928-31)
03-22-2017, 10:10 PM
|
Replies: 9
Views: 1,915
ignition switch repair
Have a 30 with intermitant ignition switch continuity issues. This is a non pop up style. The switch body is diecast, the back of the switch is crimped in place. Anyone had success removing and...
|
Forum: Model A (1928-31)
03-18-2017, 04:41 PM
|
Replies: 4
Views: 1,296
Horn issue
Have a 30 coupe with a 6 volt generator. When the engine is not running the horn works fine. When the engine is running it also works OK.
Turn on the headlights and the horn barely sounds at all....
|
Forum: Model A (1928-31)
03-08-2017, 03:32 PM
|
Replies: 9
Views: 2,054
Re: hood differences
Not the frame, which was I had thought. I removed the body, checked the frame for sagging, it was not bad, less than 1/8" of sag, so I straightened it, now it's as close to perfect as I can get....
|
Forum: Model A (1928-31)
03-07-2017, 11:12 PM
|
Replies: 9
Views: 2,054
Re: hood differences
On my 30 coupe the length at the top of the hood side aprons measure 31.5" at the top.
30" at the bottom measuring front to back. This leaves a 1/2" gap at the bottom.
Is this standard with a 30...
|
Forum: Model A (1928-31)
03-07-2017, 09:19 PM
|
Replies: 9
Views: 2,054
hood differences
Is the hood design from a 28-29 different from one used on a 30-31?
Dave Eddie
|
Forum: Model A (1928-31)
02-11-2017, 02:50 PM
|
Replies: 344
Views: 65,053
|
Forum: Model A (1928-31)
02-10-2017, 05:59 PM
|
Replies: 70
Views: 11,050
Re: What movie has the best car chase? Also......
Hands down best has to be Bullet, spectacular but believable. Plus as time goes on I admire all the Old Cars parked along the streets, when I first saw this movie those same cars where not so old.......
|
Forum: Model A (1928-31)
07-13-2016, 11:47 PM
|
Replies: 30
Views: 6,477
Re: Questions for engine experts
Check the compression tonight, low cyl is 60, high cylinder is 68, which doesn't seem terribly bad. Also did an oil change and went to a slightly heavier oil 15w-40.
Same result,...still smoking at...
|
Forum: Model A (1928-31)
07-13-2016, 01:29 PM
|
Replies: 30
Views: 6,477
Re: Questions for engine experts
I know, leave well enough alone is proly the smart thing to do, but I hate cars that smoke. This motor uses next to no oil, runs great, and up untill a week or so , never smoked. I think I'll do a...
|
Forum: Model A (1928-31)
07-12-2016, 10:58 PM
|
Replies: 30
Views: 6,477
Re: Questions for engine experts
I's been a lllong time I know, but I am wondering how you made out with the smoking issue? My 30 has the same symptoms.
Dave Eddie
|
Forum: Model A (1928-31)
07-12-2016, 10:41 PM
|
Replies: 38
Views: 7,017
|
Forum: Model A (1928-31)
06-01-2016, 10:10 AM
|
Replies: 4
Views: 1,243
Generator output
With the installation of a powerhouse generator, can you expect to run more accessories, upgraded head lights, or driving lights etc?
Dave
|
Forum: Model A (1928-31)
05-29-2016, 06:52 PM
|
Replies: 2
Views: 1,430
Powerhouse generator swap
I picked up a rebuilt powerhouse generator at a swap meet this weekend. Mainly to use as a spare for touring etc.
I have a cylinderical generator on my 30 coupe which is working fine.
Is the...
|
Forum: Model A (1928-31)
03-10-2016, 11:54 PM
|
Replies: 29
Views: 10,616
|
Forum: Model A (1928-31)
03-09-2016, 06:22 PM
|
Replies: 29
Views: 10,616
Re: Hood alignment
If this is really such a common model A issue, I wonder if it may be wise to fishplate this section of the frame to add support,.....or maybe once it's straighten it will take another 80 years or so...
|