Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 26
Search took 0.00 seconds.
Search: Posts Made By: kevinanderson
Forum: Early V8 (1932-53) 09-12-2020, 06:45 PM
Replies: 7
Views: 628
Posted By kevinanderson
Re: Sale in peirce, ne. 9/12/20

Most of them had drive trains. Not so much glass and interiors. Of course floor boards were mostly none existent. I looked under a lot hoods. There was a i think, a56 lincoln 2dr hdtp. Baby blue...
Forum: Early V8 (1932-53) 09-12-2020, 06:39 PM
Replies: 7
Views: 628
Posted By kevinanderson
Re: Sale in peirce, ne. 9/12/20

I believe the engine was in that one.
Forum: Early V8 (1932-53) 09-11-2020, 01:50 PM
Replies: 7
Views: 628
Posted By kevinanderson
Sale in peirce, ne. 9/12/20

Www.equipmentfacts.com.
Richard and joan schulz
Car and truck auction

Some intersting early v8 stuff. All PRETTY rough. A few panel deliveries and woodies. Enjoy.
Forum: Early V8 (1932-53) 05-13-2020, 09:21 PM
Replies: 9
Views: 669
Posted By kevinanderson
Re: Brake system flushing

I used brake cleaner with the straw on the nozzel and blew out the lines, one at a time. Then blew good clean air thru it.
Forum: Early V8 (1932-53) 03-08-2020, 09:42 PM
Replies: 100
Views: 6,849
Posted By kevinanderson
Forum: Early V8 (1932-53) 02-03-2020, 09:34 PM
Replies: 100
Views: 6,849
Posted By kevinanderson
Re: So much for Irish Spring and Dryer Sheets.....

I put green kool-aid or pellets in a shallow container and then place a milk crate upside down over it. Weight it down if i have too.
Forum: Early V8 (1932-53) 08-15-2018, 12:32 PM
Replies: 42
Views: 3,271
Posted By kevinanderson
Re: Rodents in headliner

How about a damn coon? And then Hagerty says sorry. That's considered vermin. Not covered.
Forum: Early V8 (1932-53) 06-12-2018, 08:52 AM
Replies: 1
Views: 505
Posted By kevinanderson
35 coupe

Any suggestions as to where I can buy a kit to replace the center section of my roof? Wood is still very nice but the screen, padding and rubber piece need replaced. Hagerty considers a coon tearing...
Forum: Early V8 (1932-53) 04-24-2018, 09:04 PM
Replies: 0
Views: 366
Posted By kevinanderson
35 standard 5 window coupe interior and roof set. Any ideas?

Any suggestions for a decent interior kit? LB? Cartouche? Same for roof center. Thanks. Kevin. Pics to insurance lady today.
Forum: Early V8 (1932-53) 04-23-2018, 07:42 PM
Replies: 26
Views: 2,554
Posted By kevinanderson
Re: Recurring problem

Been through this. After new everything, discovered the mounting plate in the distributor was ever so slightly warped. Once it got real good and warm/hot, it would expand and ground itself out. Same...
Forum: Early V8 (1932-53) 09-26-2011, 08:51 PM
Replies: 3
Views: 2,530
Posted By kevinanderson
Weak spark/6volt

First, forgive me if tnis question has been asked alot. Ive got a 48 block with a crab distributer. Dist was set up on a Sun machine. Everything is new. Tried 2 new umiversal coils. Condensor from a...
Forum: Early V8 (1932-53) 11-13-2010, 12:26 AM
Replies: 3
Views: 1,053
Posted By kevinanderson
Re: 1935 ford splash pan

I had one made. Looks and fits well. Searched and searched for one to no avail.
Forum: Early V8 (1932-53) 10-11-2010, 08:56 PM
Replies: 4
Views: 1,462
Posted By kevinanderson
36 fuel gauge recalibration

So I need to send out my gauge along with the Drake sending unit and get them. Matched up ?
Forum: Early V8 (1932-53) 07-09-2010, 03:55 PM
Replies: 0
Views: 838
Posted By kevinanderson
hubcap question

On my '35 coupe. Running reversed merc rims on rear. Is there a dog dish that will fit the wide hub and the axle snout? Thanks-Kevin
Forum: Early V8 (1932-53) 06-18-2010, 03:11 PM
Replies: 2
Views: 1,235
Posted By kevinanderson
Original finish

Is the original exterior paint paint on a '35 enamel? How does it take to touching up?
i'vr got a few good sized scrapes by the trunk. and they are very distracting to the rest of the car. thanks,...
Forum: Early V8 (1932-53) 06-08-2010, 09:17 AM
Replies: 108
Views: 19,649
Posted By kevinanderson
Re: Tell us what your working on !

'35 Standard 5 window keep that has been in the family since '57. My Dad paid 195.00 for it and buying it about put him under financially. Car has never left the area of purchase. Have the dealer's...
Forum: Early V8 (1932-53) 06-05-2010, 10:41 PM
Replies: 16
Views: 4,275
Posted By kevinanderson
Re: Bob Drake Fuel Sending Unit?

i just put in a bob drake tank in my 35 coupe. it went in easily and everything lined up well.
Forum: Early V8 (1932-53) 05-31-2010, 11:20 AM
Replies: 13
Views: 1,844
Posted By kevinanderson
Re: Fenderskirt Question

Thanks for the input, guys. I like the overlap look, like on the '36 pictured above. But, as Neal said, The height of the opening is greater than that of the skirt. I have that problem with my '48...
Forum: Early V8 (1932-53) 05-29-2010, 11:52 AM
Replies: 13
Views: 1,844
Posted By kevinanderson
Fenderskirt Question

'35 and '36 the same?
Forum: Early V8 (1932-53) 05-23-2010, 11:17 PM
Replies: 2
Views: 1,186
Posted By kevinanderson
50lb oil pressure sender

i read somewhere that a willys unit was a better than one advertised in the ford catalogs. is this true? can't find that web site. can someone point me in that direction. Have a SW mechanical unit,...
Forum: Early V8 (1932-53) 05-23-2010, 10:11 AM
Replies: 0
Views: 1,040
Posted By kevinanderson
Radio Question

Will the head and cables from a '35 hook up to the radio box from a '37?
Forum: Early V8 (1932-53) 05-23-2010, 02:10 AM
Replies: 8
Views: 2,572
Posted By kevinanderson
6 Volt Electronic Ignition

Anyone have their dist. changed over to electronic ignition? Good deal or ? I see there is a guy advertising change overs in Hemmings.
Forum: Early V8 (1932-53) 05-18-2010, 02:22 PM
Replies: 3
Views: 1,143
Posted By kevinanderson
Gas gauge/tank sender question

Putting a new Drake tank and sender unit in my '35. Is it pretty much a drop in with the original gauge, ohm wise? Or do I need to do anything beside just measure the float rod? Thanks, Kevin
Forum: Early V8 (1932-53) 05-15-2010, 07:23 PM
Replies: 15
Views: 1,856
Posted By kevinanderson
Re: Underhood clean up

75 years worth of grunge. was leary of the steel wool. hood is off and standing on end. don't want to stain the exterior of hood. 39k mile car.
Forum: Early V8 (1932-53) 05-13-2010, 02:00 PM
Replies: 15
Views: 1,856
Posted By kevinanderson
Underhood clean up

Anyone have a suggestion for cleaning the underside of my '35 hood. I thought about using Dawn dish soap and some fine steel wool.
Showing results 1 to 25 of 26

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 05:11 PM.