Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 18 of 18
Search took 0.00 seconds.
Search: Posts Made By: brentom
Forum: Early V8 (1932-53) 11-07-2014, 10:38 PM
Replies: 2
Views: 861
Posted By brentom
Forum: Early V8 (1932-53) 11-07-2014, 09:17 PM
Replies: 2
Views: 861
Posted By brentom
1940 mercury coupe headlight buckets

Hello Gents and happy Friday,

I am in search of headlight buckets for my 40 Merc coupe, will the 40 Ford coupes, sedan or otherwise work? If not, any suggestions?
Regards,

Tom
Forum: Early V8 (1932-53) 05-07-2014, 06:29 PM
Replies: 3
Views: 923
Posted By brentom
Forum: Early V8 (1932-53) 05-07-2014, 11:33 AM
Replies: 3
Views: 923
Posted By brentom
Smile 1940 mercury coupe spear moldings

Gentlemen and Ladies,

would the body spear moldings on a 40 ford coupe fit on a 40 Mercury coupe, based on some photo comparison it appear they are the same?

feedback appreciated,
Forum: Early V8 (1932-53) 08-22-2013, 08:34 PM
Replies: 9
Views: 1,846
Posted By brentom
Re: 39 ford flathead

ok gents, i will post after i take some of the suggestions, been busy at work, maybe tomorrow evening or sat.
Forum: Early V8 (1932-53) 08-21-2013, 09:22 PM
Replies: 9
Views: 1,846
Posted By brentom
Re: 39 ford flathead

Yes back fires on deceleration
Forum: Early V8 (1932-53) 08-21-2013, 09:20 PM
Replies: 9
Views: 1,846
Posted By brentom
Re: 39 ford flathead

I'm in highland lakes nj, appreciate your feedback I will follow up in the am with your suggestions

Tom
Forum: Early V8 (1932-53) 08-21-2013, 09:29 AM
Replies: 9
Views: 1,846
Posted By brentom
39 ford flathead

My original 39 ford was running fine with the exception of backfiring on decal, well it stopped running, I have spark, I have fuel, when squirting the carb it fire for two secs, can't keep it...
Forum: Early V8 (1932-53) 06-01-2013, 08:37 PM
Replies: 7
Views: 1,356
Posted By brentom
Re: 1949 Mercury 2x2 linkage carb set up ?

Thank Ken, don't know if you recall, a few months ago I called you regarding rebuilding of the stock air horn/carb, decided to go this 2x2 set up, I will keep you in mind for future reference.
Forum: Early V8 (1932-53) 06-01-2013, 07:09 PM
Replies: 7
Views: 1,356
Posted By brentom
1949 Mercury 2x2 linkage carb set up ?

Need help, I bought this 2x2 carb set up as a bolt on, all good, except when I attach the gas pedal rod ball to the the linkage shaft it push in the wrong direction(against the idle screw) need a...
Forum: Early V8 11-04-2012, 09:42 PM
Replies: 5
Views: 3,077
Posted By brentom
Forum: Early V8 (1932-53) 11-04-2012, 09:22 PM
Replies: 4
Views: 1,106
Posted By brentom
Cool Acceleration uphill

When Accelerating uphill, my 49 stock Merc motor, cuts out. This only happens on steep inclines. Any help appreciated.

Tom
Forum: Early V8 (1932-53) 06-18-2011, 07:03 PM
Replies: 16
Views: 2,515
Posted By brentom
My 49 mercury water pump

Will 51 merc motor water pumps work on the 49? I have a donor 51 with the original flathead in tack and want to remove the water pumps and send to get rebuild then install in my 49 mercury and not...
Forum: Early V8 (1932-53) 04-28-2011, 07:23 AM
Replies: 6
Views: 1,425
Posted By brentom
Re: 1949 Mercury starter

thanks to aal on your replys. this forum is greatly apprecciatted:cool:
Forum: Early V8 (1932-53) 04-27-2011, 11:06 AM
Replies: 6
Views: 1,425
Posted By brentom
1949 Mercury starter

where to buy new? or rebuild? 1949 Mercury 6Volt starter.

Thanks,

Tom
Forum: Early V8 02-25-2011, 07:52 PM
Replies: 4
Views: 1,619
Posted By brentom
Re: 59AB Offenhauser heads-originals-NICE

will these work on my 50 mercury flathead? I believe, but wan to double check.
Forum: Early V8 (1932-53) 12-18-2010, 04:14 PM
Replies: 6
Views: 5,887
Posted By brentom
Forum: Early V8 (1932-53) 12-18-2010, 03:25 PM
Replies: 6
Views: 5,887
Posted By brentom
1949 Mercury flathead water pump

it appears I have antifreeze leaking from the drivers side, I assume it is the water pump, my questions are:

1. Is Ford and Mercury water pumps the same?
2. Do I rebuild or buy new?

Thanks,...
Showing results 1 to 18 of 18

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 05:39 AM.