Forum: Model A (1928-31)
04-28-2024, 05:21 PM
|
Replies: 11
Views: 968
Re: Winfield Model M updraft carb
Here are two Model M-B's with the choke horns they came with. At first they were thought to be cut down silencer horns, but the silencer horns were to short to cut down and end up with these. One...
|
Forum: Model T (1909-1927)
12-31-2023, 05:37 AM
|
Replies: 12
Views: 2,061
|
Forum: Model T (1909-1927)
12-30-2023, 01:24 AM
|
Replies: 12
Views: 2,061
Re: Ruckstell axle...underdrive or overdrive?
If the rear is jacked up with both wheels in the air, the action of the differential can throw the test off, sometimes one wheel will spin in the opposite direction, depending on the drag within the...
|
Forum: Model T (1909-1927)
12-29-2023, 01:14 AM
|
Replies: 12
Views: 2,061
Re: Ruckstell axle...underdrive or overdrive?
The Ruxtell axle is a two speed rear axle. The standard Model T ring gear has 40 teeth with an 11 tooth pinion. This would give a lower low, a standard low, a lower high and a standard high. Great...
|
Forum: Model A (1928-31)
11-01-2023, 07:51 PM
|
Replies: 4
Views: 645
|
Forum: Model A (1928-31)
06-24-2023, 11:14 PM
|
Replies: 4
Views: 859
Re: Oil filter question - Kenz adapter
The FL-1A works fine as do the other manufacturers equivalents. I like the Wix that is shorter than the FL's since I have a 90 degree adapter on the original purchased from Bill Kenz adapter I have....
|
Forum: Model T (1909-1927)
06-24-2023, 11:08 PM
|
Replies: 17
Views: 2,561
Re: Brass T Battery Back In The Day
The batteries were like that example or similar. Four of those for six volts was enough to fire off the ignition and then switch over to mag, although a good mag works just fine. My '11 never carried...
|
Forum: Model T (1909-1927)
04-05-2023, 01:14 AM
|
Replies: 61
Views: 12,294
|
Forum: Model T (1909-1927)
03-09-2023, 06:38 PM
|
Replies: 10
Views: 1,820
Re: Unusual Ford Wrenches
The tools in the 1906 through 1909 parts books don't show a logo, although the Ford logo on the radiators of the 1906-08 Models N, R & S, all had a script that was supposed to imitate Henry's actual...
|
Forum: Model T (1909-1927)
03-09-2023, 12:01 AM
|
Replies: 10
Views: 1,820
Re: Unusual Ford Wrenches
Here are three wrenches with variations of the Ford script. The lower one is from about 1911-1914. The next one up is its replacement, it started appearing in mid-late 1913 as the log was changed and...
|
Forum: Model T (1909-1927)
02-09-2023, 09:45 PM
|
Replies: 14
Views: 5,560
Re: What kind of car is this?
Not a Stanley, Locomobile either. I thought it was a Duyea at first glance but no.
I believe it is a steam car too, just can't seem to find one that matches it in my literature. Its not one of the...
|
Forum: Model A (1928-31)
12-23-2022, 06:34 PM
|
Replies: 242
Views: 76,794
Re: what other old cars are in your garage?
Woofa, I guess you are referring to the number plate? It is a copy of the decayed original leather using the original brass numbers. It may be registered and insured for limited use only
|
Forum: Model A (1928-31)
12-23-2022, 06:25 PM
|
Replies: 242
Views: 76,794
|
Forum: Model A (1928-31)
12-07-2022, 03:46 PM
|
Replies: 242
Views: 76,794
|
Forum: Model T (1909-1927)
11-10-2022, 08:14 PM
|
Replies: 7
Views: 1,589
Re: Radiator cap
If you know the outside diameter, look for a 'Dog Bone' radiator cap, they seem the have the same thread pitch and will generally fit all of the replacement and accessory Model T radiators with the...
|
Forum: Model A (1928-31)
09-23-2022, 08:42 PM
|
Replies: 7
Views: 1,414
|
Forum: Model A (1928-31)
09-15-2022, 09:12 PM
|
Replies: 59
Views: 8,365
Re: Oil filter for KENZ oil filter kit?
Can't say, there are no engine pans on mine.
Good question.
Later-
Got curious and went out to the car, the KENZ setup with the vertical adapter would make interference between the pan and...
|
Forum: Model A (1928-31)
09-12-2022, 11:36 PM
|
Replies: 59
Views: 8,365
Re: Oil filter for KENZ oil filter kit?
The KENZ filter has worked well for me for many years. Mainly used the FL-1 filters, has a WIX on it at present. It does have a 90 degree adapter from an old mid-sixties Ford six that makes...
|
Forum: Model T (1909-1927)
08-09-2022, 05:56 PM
|
Replies: 5
Views: 1,212
|
Forum: Model T (1909-1927)
08-08-2022, 01:57 PM
|
Replies: 5
Views: 1,212
|
Forum: Model T (1909-1927)
08-07-2022, 06:41 PM
|
Replies: 4
Views: 1,323
|
Forum: Model T (1909-1927)
08-07-2022, 06:28 PM
|
Replies: 5
Views: 1,212
Re: Holley carb for Model S Ford
The N-R-S Holley has a screen over the intake and no 'choke' as such. It has a flood button that depresses the float for starting....
|
Forum: Model A (1928-31)
07-23-2022, 06:31 PM
|
Replies: 16
Views: 3,549
|
Forum: Model A (1928-31)
04-24-2022, 12:51 AM
|
Replies: 37
Views: 6,441
Re: B Carb on an A?
Regarding the breaking of B carb mounting ears: Using a gasket that is thicker than the thin one supplied in the gasket kits, such as the laminated copper one or thicker fiber gaskets puts too much...
|
Forum: Model A (1928-31)
04-24-2022, 12:38 AM
|
Replies: 63
Views: 11,490
|