Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 16 of 16
Search took 0.00 seconds.
Search: Posts Made By: 47jailbar
Forum: Early V8 (1932-53) 06-04-2024, 02:44 PM
Replies: 4
Views: 366
Posted By 47jailbar
Re: Gear lube

Thanks Glenn. I suppose that’s a possibility. It’s been converted to an open driveshaft (I’m guessing sometime in the ‘90’s) but it could have been sloshing around in there for all that time.
Forum: Early V8 (1932-53) 06-04-2024, 01:37 PM
Replies: 4
Views: 366
Posted By 47jailbar
Gear lube

I just changed the transmission fluid in my ‘47 3 spd. Along with the 90 weight out came something that looked like a shot or two of grease. Any ideas as to what that was (the transmission has been...
Forum: Early V8 (1932-53) 12-17-2023, 09:02 PM
Replies: 22
Views: 1,475
Posted By 47jailbar
Re: Vibration

I doubt it’s wheel/tire related as there is no vibration at low speeds and seems to be more dependent on engine RPM; at shift points and above 45 mph in third. No tach installed at this time however...
Forum: Early V8 (1932-53) 12-17-2023, 07:45 PM
Replies: 22
Views: 1,475
Posted By 47jailbar
Re: Vibration

Sounds like a plan. I’m going to drop the driveshaft and change u joints at the same time I do the trans mount. If that doesn’t do it I’ll have the driveshaft balanced.
Forum: Early V8 (1932-53) 12-17-2023, 12:24 PM
Replies: 22
Views: 1,475
Posted By 47jailbar
Re: Vibration

Thanks. Logical diagnostic is exactly what I need. It sure sounds like transmission but to be honest I havenÂ’t tried to go faster than the vibration start point because it shakes so bad. I guess...
Forum: Early V8 (1932-53) 12-16-2023, 01:07 PM
Replies: 22
Views: 1,475
Posted By 47jailbar
Re: Vibration

OK, thanks guys, that gives me a good place to start. Think I’ll still change tranny mount as it looks pretty rough. Is there a torque spec?
Forum: Early V8 (1932-53) 12-16-2023, 11:26 AM
Replies: 22
Views: 1,475
Posted By 47jailbar
Re: Vibration

No only while moving with trans engaged
Forum: Early V8 (1932-53) 12-16-2023, 09:28 AM
Replies: 22
Views: 1,475
Posted By 47jailbar
Re: Vibration

I just bought the truck from a broker and, unfortunately, I donÂ’t know any of its history
Forum: Early V8 (1932-53) 12-16-2023, 08:49 AM
Replies: 22
Views: 1,475
Posted By 47jailbar
Vibration

I have a ‘47 1/2 ton, period correct v8, 3spd manual, 4.11 banjo. Has a bad vibration just before I shift and at speeds above 45 mph. It makes no unusual noises. Motor mounts look recent, no...
Forum: Early V8 (1932-53) 11-14-2023, 08:21 PM
Replies: 15
Views: 1,204
Posted By 47jailbar
Re: New (patients please)

Auburn is a bit far given the gearing in the old girl. I’ll probably do NSRA nationals in Kalamazoo though.
Forum: Early V8 (1932-53) 11-14-2023, 05:32 PM
Replies: 15
Views: 1,204
Posted By 47jailbar
Forum: Early V8 (1932-53) 11-14-2023, 12:53 PM
Replies: 15
Views: 1,204
Posted By 47jailbar
Re: New (patients please)

I put some pics in an album. Still trying to figure out how to add them to a post.
Forum: The Test Forum 11-14-2023, 03:08 AM
Replies: 1
New
Views: 1,039
Posted By 47jailbar
Re: New

Pics
Forum: Early V8 (1932-53) 11-13-2023, 03:35 PM
Replies: 15
Views: 1,204
Posted By 47jailbar
Re: New (patients please)

Thank you much one and all. I plan on ordering a 42-47 manual I saw on eBay. Seller says it’s a reproduction of a military manual.
Forum: The Test Forum 11-13-2023, 10:21 AM
Replies: 1
New
Views: 1,039
Posted By 47jailbar
New

New to all forums. Just checking in.
Forum: Early V8 (1932-53) 11-13-2023, 09:43 AM
Replies: 15
Views: 1,204
Posted By 47jailbar
New (patients please)

IÂ’m not only new to Fordbarn, IÂ’m new to forums, boards ext so please bear with me. I donÂ’t know where to post my question so IÂ’m starting here.

IÂ’ve just purchased a 1947 Ford pickup (1/2...
Showing results 1 to 16 of 16

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 12:35 AM.