Forum: Early V8 (1932-53)
Yesterday, 09:26 AM
|
Replies: 15
Views: 552
|
Forum: Early V8 (1932-53)
05-31-2024, 09:55 PM
|
Replies: 15
Views: 552
|
Forum: Early V8 (1932-53)
05-31-2024, 02:25 PM
|
Replies: 15
Views: 552
|
Forum: Early V8 (1932-53)
05-31-2024, 11:36 AM
|
Replies: 15
Views: 552
|
Forum: Model A (1928-31)
05-31-2024, 11:33 AM
|
Replies: 8
Views: 456
Re: Cast fuel bowl leaking- round two
Need to thank 1crosscut for his suggestion. I really watched closely and it turned out the source of the leak was coming from the inside fuel line needing to be snugged up against the male nipple...
|
Forum: Early V8 (1932-53)
05-31-2024, 11:06 AM
|
Replies: 7
Views: 384
|
Forum: Early V8 (1932-53)
05-29-2024, 03:40 PM
|
Replies: 15
Views: 614
|
Forum: Early V8 (1932-53)
05-29-2024, 09:05 AM
|
Replies: 15
Views: 614
Re: Boling Brothers Brakes Question
I did the same thing. I used old fashioned stick chalk and scribbled on the pads. Keep working until all of the chalk was removed when brake was applied. It didn't take long with some 80 grit...
|
Forum: Early V8 (1932-53)
05-29-2024, 06:57 AM
|
Replies: 15
Views: 614
|
Forum: Model A (1928-31)
05-29-2024, 04:29 AM
|
Replies: 8
Views: 456
Re: Cast fuel bowl leaking- round two
Thanks, Dave. I'm fairly certain it's coming from there. I've done the paper towel dabbing trick and it always underneath the screw. It's small enough that it will "pool" up for a bit on the flat...
|
Forum: Model A (1928-31)
05-28-2024, 08:49 PM
|
Replies: 8
Views: 456
Cast fuel bowl leaking- round two
OK, so I posted a while back about my weeping/leaking cast fuel bowl for a '28 roadster. I recent took it off, ground the internal vertical seat that the drain needle seats in with a stone, found a...
|
Forum: Early V8 (1932-53)
05-28-2024, 06:36 PM
|
Replies: 26
Views: 824
|
Forum: Early V8 (1932-53)
05-28-2024, 06:36 PM
|
Replies: 26
Views: 824
Re: Pictures after head swap (hot rod content)
Thank you, GB. I'll post some full car shot in a bit. Warning, it's an old hot rod and may have the worst fuel efficiency of any car I've owned. I've calculate 12-14 mph. It could be because...
|
Forum: Early V8 (1932-53)
05-28-2024, 06:34 PM
|
Replies: 26
Views: 824
|
Forum: Early V8 (1932-53)
05-28-2024, 11:07 AM
|
Replies: 26
Views: 824
|
Forum: Early V8 (1932-53)
05-28-2024, 09:34 AM
|
Replies: 26
Views: 824
|
Forum: Early V8 (1932-53)
05-27-2024, 12:13 PM
|
Replies: 26
Views: 824
|
Forum: Early V8 (1932-53)
05-27-2024, 09:06 AM
|
Replies: 26
Views: 824
|
Forum: Early V8 (1932-53)
05-27-2024, 08:54 AM
|
Replies: 26
Views: 824
Re: Pictures after head swap (hot rod content)
Unfortunately, I did. The two casting "nubs" on the lower section of fins on each head weeped. I finally got them to stop with 2 doses of liquid glass, but it was still bugging me that it was...
|
Forum: Early V8 (1932-53)
05-27-2024, 08:51 AM
|
Replies: 26
Views: 824
|
Forum: Early V8 (1932-53)
05-27-2024, 08:18 AM
|
Replies: 26
Views: 824
|
Forum: Early V8 (1932-53)
05-27-2024, 08:18 AM
|
Replies: 26
Views: 824
|
Forum: Early V8 (1932-53)
05-27-2024, 07:20 AM
|
Replies: 26
Views: 824
Pictures after head swap (hot rod content)
Finished swapping the Cyclone heads to new Edelbrocks. Hard to tell, but I polished the sides and fin tops. I guess I'll need to do the intake next winter, haha.
Happy to find the NOS...
|
Forum: Early V8 (1932-53)
05-26-2024, 04:39 PM
|
Replies: 19
Views: 693
|
Forum: Early V8 (1932-53)
05-26-2024, 08:19 AM
|
Replies: 19
Views: 693
|