The Ford Barn

The Ford Barn (https://www.fordbarn.com/forum/index.php)
-   Model A (1928-31) (https://www.fordbarn.com/forum/forumdisplay.php?f=3)
-   -   Popout switch not popping out (https://www.fordbarn.com/forum/showthread.php?t=41689)

Gary WA 07-09-2011 10:44 AM

Popout switch not popping out
 

Switch works if your gentle turning it on but does not pop out, causes??:confused:

Joop 07-09-2011 10:47 AM

Re: Popout switch not popping out
 

Is it a pop out or later turn one ?

If original it could have a broken spring inside or rubbing against the housing.

Gary WA 07-09-2011 11:05 AM

Re: Popout switch not popping out
 

Original.

Tom Wesenberg 07-09-2011 11:23 AM

Re: Popout switch not popping out
 

Broken spring? I've seen some originals that were so gummed up from years of crud and not being used, but if your's has been working fine and sudeenly doesn't my guess is a bad spring or the peg doesn't fully retract to allow the cylinder to pop out. Either way, it sounds like it need to come apart and be repaired or cleaned and lubed.

Milton 07-09-2011 12:29 PM

Re: Popout switch not popping out
 

Quote:

Originally Posted by Gary WA (Post 236248)
Switch works if your gentle turning it on but does not pop out, causes??:confused:

Because it is a poop out. :D

Chris Haynes 07-09-2011 01:54 PM

Re: Popout switch not popping out
 

My Pop Out works just fine as long as it is straight. But when you bend the coil to install it it shorts out. :-(

jw hash 07-09-2011 02:53 PM

Re: Popout switch not popping out
 

if it is a 28-29 or early 30 pop out and it does not pop out my bet is the pot metal is swelling up or the spring is broke but must of time it is the pot metal if you take it apart and sand the outside of the inners down lube it and put it back together it should work

Gary WA 07-09-2011 06:16 PM

Re: Popout switch not popping out
 

thanks will investigate further. Have a Good Weekend.

FL&WVMIKE 07-09-2011 06:27 PM

Re: Popout switch not popping out
 

Gary WA ................
WD-40 works wonders on sticky locks. Try that first.
MIKE :)

Gary WA 07-09-2011 06:48 PM

Re: Popout switch not popping out
 

Quote:

Originally Posted by FL&WVMIKE (Post 236452)
Gary WA ................
WD-40 works wonders on sticky locks. Try that first.
MIKE :)

It's in the car should I just spray in the key area?:confused:

Chris Haynes 07-09-2011 10:42 PM

Re: Popout switch not popping out
 

I would spray some electrical contact cleaner in it rather than WD40 which will attract dust and gum things up.

Tom Wesenberg 07-09-2011 11:20 PM

Re: Popout switch not popping out
 

I've heard that WD-40 is bad for potmetal. I know it's sure bad for plastic containers. I sprayed some WD-40 on some hardware in a plastic container and a week later the plastic was out of shape.

Bob from Northport 07-09-2011 11:30 PM

Re: Popout switch not popping out
 

Remove the switch-contact Dick Crabtree in S. Dakota, send it to him, and get it redone.

1-605-487-7229 He's great!

Gary WA 07-10-2011 07:07 PM

Re: Popout switch not popping out
 

Thanks for all the tips. But the screws that hold the switch to the dash panel came loose on one side hung up on panel.. Thanks again!! making it sit at an angle.


All times are GMT -5. The time now is 06:36 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.