Holley 94 carburetor spacer
 

I'm looking for a good source for Ford Flathead carburetor spacers. My 8BA sits with a slight tilt and I would like to get my carbs sitting correctly without the slight lean. I'm running 3 Holly 94's on an Edelbrock intake. Thanks.

Re: Holley 94 carburetor spacer
 

I use to think my carb was getting overheated from the intake manifold and bought a spacer to deter heat transfer to carb body. However its a uniform thickness. Its a plastic based material and I suppose one could have a machine shop mill it down to provide a level surface - one for each carb. Might have to do some carb linkage adjustments.

Re: Holley 94 carburetor spacer
 

Thanks, I thought someone told me that somewhere they make them with an angled top edge that you could get in different degrees based on your situation. I'll keep checking back here in case that outfit exists somewhere. Thanks for your reply.

Re: Holley 94 carburetor spacer
 

Here you go


https://www.ebay.com/itm/236276874329

Re: Holley 94 carburetor spacer
 

https://i.ebayimg.com/images/g/SPgAA...Etp/s-l500.jpg
See also > https://www.ebay.com/sch/i.html?_nkw...sid=m570.l1313

Re: Holley 94 carburetor spacer
 

The seller can also supply angles opposite of the one pictured.