Side Bowl Carburetor question
 

I recently acquired a side bowl carburetor. The top of the carburetor with the side bowl filter is on a Zenith-2 base. Were these side bowls carburetor produced as a Zenith-2 or Zenith-3.

Re: Side Bowl Carburetor question
 

Both- Zenith-2 was Holley Built and a zenith-1 built by zenith. The Ford built zenith-3.Used on late 31 A's

Re: Side Bowl Carburetor question
 

Hello Keith--Could you provide a front and back pictures of your side bowl carburetor top and bottom castings? Then I could tell you if they are correctly matched or not.

Re: Side Bowl Carburetor question
 

Picture of three views side bowl carb.
Keith

Re: Side Bowl Carburetor question
 

Thank you Keith for the pictures. It is a correctly mated Holley side bowl carburetor. Both the bottom and top casting are correct. Holley made only one variety, used with the introduction of the indented firewall vehicles, from April 1931 to end of production. Zenith made 3 varieties of the side bowl carb during that same period.

Re: Side Bowl Carburetor question
 

Steve,

Thank you for the feedback on the carb. Keith