Correct torque for rod and main caps?
 

I read in Jim Schild's "Restore's Model A Shop Manual"
proper torque for mains is 50 and rods is 35

I've been told
mains should be 80 and rods 50
What is the correct torque? We are just removing some shims.
Thanks

Re: Correct torque for rod and main caps?
 

Main 80, rods 35

Re: Correct torque for rod and main caps?
 

For the Burtz engine, Terry recommends 55 ft-lbs for the mains and 40-45 ft-lbs for the rods. I used 65 ft-lbs for the rear main.

Re: Correct torque for rod and main caps?
 

That clears it up doesn't it ! [ smiley face]