Fan Blade Nut
 

When you replace the fan how much should you tighten the nut and is there a torque spec

Re: Fan Blade Nut
 

My experience is that the first time you tighten it, the next day after a short spin it will require retightening.

Re: Fan Blade Nut
 

Hopefully it is a reproduction style that is aluminum. With that said you should place a steel washer under the castle nut. If you don't it will loosen. Grab the fan and try to shake it before starting when you check under the hood. This is a good safety check to see if it is loose. Be safe not sorry. Do this often

Re: Fan Blade Nut
 

I agree... check it each time after the first three drives

Re: Fan Blade Nut
 

Thanks

Re: Fan Blade Nut
 

When installing the fan on the water pump shaft, drop the opposite end of the water pump shaft a couple of times on something hard like on the flat spot surface on the top of a vice with the fan snug on the shaft to seat it good. Then place the steel washer under the castelated nut and tighten snuggly. Do not back off to get the holes to line up, but tighten.

Re: Fan Blade Nut
 

If the "look" doesn't bother you, consider a six-blade plastic fan.