Brake Switch Wiring Connection
 

The original brake switch on my 49 F1 finally no longer works. In this original switch the prongs have a hole for the wires and grub screws to fasten them.
On this replacement switch how are the wires fastened to the prongs? There are no threaded screws or holes, only 2 grooves in each of the prongs.
Thanks in advance.

Re: Brake Switch Wiring Connection
 

You should be able to get some solder-less connectors that you can crimp onto the ends of the wires. Then push them onto the switch.

Re: Brake Switch Wiring Connection
 

They're called bullet connectors. Usually, the wires have male ends attached and connect together via a female 'tube' connector. Now you can also just get a female connector type. This is what you need. Commonly available.

Re: Brake Switch Wiring Connection
 

Female bullet connector is required

Re: Brake Switch Wiring Connection
 

That makes sense. Thanks for your help everyone.