59A into 32 frame motor mounts
 

Does anyone have or know where I can find the motor mount location for putting a 59a into a '32 frame. I plan to build my own motor mounts that mount to the sides of the frame.

Re: 59A into 32 frame motor mounts
 

These are actual 1932 motor mounts, if that helps any. These would be relatively easy to duplicate. DD

http://www.fordbarn.com/forum/attach...5&d=1468945745

Re: 59A into 32 frame motor mounts
 

I have an A front crossmember so the original style mounts won't work for me. Thanks for the picture though.

Re: 59A into 32 frame motor mounts
 

Follow the Hurst instructions for the side mounts that bolt or weld to frame rails, anything similar to Hurst part A-28. You bolt the enginr to transmission and trans to crossmember, decide on front height, and put the mounts under the pump legs.

Re: 59A into 32 frame motor mounts
 

Stock flathead engine height can be estimated from the crank bearing on front spring clamp and/or crank hole in grill...crank has to go through that hole to center of crankshaft on a '32. You have higher crossmember there, of course, but estimating shouldn't be hard.