Rear Motor Mount Bolts Just sorting out some bolts to install the rear motor mount to the flywheel housing . I have some that would do but are cross drilled for a lock wire and some plain.
Originally were they lock wired or with a lock washer . Just curious . John in lovely locked down Spring Weather Suffolk County England . |
Re: Rear Motor Mount Bolts Originals where drilled to accept cotter (split ) pins.
Quite nice here too in Nassau County, along side Suffolk County, USA jb |
Re: Rear Motor Mount Bolts Per RG/JS, Sec 1-9,
"The heads of the bolts were safety wired in various ways with 18 gauge plain or raven finished wire." No mention of lock washers.... TallyHo |
Re: Rear Motor Mount Bolts Ooops, Should have typed:
Section 1-5 Revised 2011 |
Re: Rear Motor Mount Bolts The rear engine mounts were bolted to flywheel housing with unfinished bolts AND lock washers and wired with 18 gauge wire which was plain or raven.
|
Re: Rear Motor Mount Bolts 1 Attachment(s)
Quote:
Quote:
Research the following; A-21207 Bolt - housing to rear engine support. A-22330 Lock Washer A-6402 Wire - engine support to flywheel housing support wire. . |
Re: Rear Motor Mount Bolts The above are correct......why did I read but think of the smaller motor mount to frame bolts???
Week 6 'Interment Camp Cuomo'......... |
Re: Rear Motor Mount Bolts Thank you all very much all is crystal clear . All my cars have lock washers and oddly enough not had any with wire . None are original so many motor changes over the years .
John in yet another glorious Spring Day we are heading for the warmest April on record and no Model A !!! Suffolk County England . |
All times are GMT -5. The time now is 01:48 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.