Rear Lower Trunk Panel Does anyone know if any of the vendors sell a Coupe rear lower trunk panel with the correct arch built in? I've looked for an original but so far no luck. On a 30-31 coupe this panel is taller in the middle by about a 1/4" compared to the ends. I believe most of the reproduction panels are straight across both top and bottom and need extensive work to fit properly. TIA
Tony |
Re: Rear Lower Trunk Panel That would be nice. More to the needed shape then just the top edge though.
|
Re: Rear Lower Trunk Panel Try Bert's. They have a lot of original panels. JP
|
Re: Rear Lower Trunk Panel I’d check with Bert’s on an original
However, I am currently completing a buck/template to make them correctly Made a first run yesterday and have to make some minor adjustments These have the correct arches etc. I have several originals to knock off from Should have them in two week if all works out. Will be $95 plus shipping to wherever These fit 28-29 coupe and all cabbys If any interest get back to [email protected] |
Re: Rear Lower Trunk Panel Had a problem with repro panel being straight across the top. Could't find a good original replacement, but did find a bad original from which I took the top reinforcement bar and spare tire reinforcement and installed same in place on the repro panel which solved the problem.
|
Re: Rear Lower Trunk Panel I tried the same thing. It sorta worked but the repo I had was too short and the gap at the base of the deck lid was too wide
That’s why I went the path of making them We shall see how it goes |
Re: Rear Lower Trunk Panel Thanks gentlemen I appreciate the advice.
|
Re: Rear Lower Trunk Panel |
Re: Rear Lower Trunk Panel Thanks Steve, great info.
|
All times are GMT -5. The time now is 09:30 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.