Re: Oil pan 59AB photos 1 Attachment(s)
Thank you so much for the photos JSeery, have the same lines and holes, that I have been drawing.
If is possible yet, can you take a close-up of the areas that I marked? Thank you very much. All the best, Jorge |
Re: Oil pan 59AB photos 2 Attachment(s)
See if this is what you are looking for. PM me your email address and I will email back the original higher res photos (around 4Mb)
|
Re: Oil pan 59AB photos Thank you JSeery.
|
Re: Oil pan 59AB photos 1 Attachment(s)
In progress :)
|
Re: Oil pan 59AB photos Hello all,
This part gave some work, now do the rest of the holes. http://i141.photobucket.com/albums/r...ps6bj42cfe.jpg http://i141.photobucket.com/albums/r...psjy2jkicw.jpg http://i141.photobucket.com/albums/r...ps2pqfb352.jpg |
Re: Oil pan 59AB photos Quote:
You are showing 8ba timing components they are different from 59a. R |
Re: Oil pan 59AB photos What are the components that are not correct?
|
Re: Oil pan 59AB photos Quote:
The timing gears R |
Re: Oil pan 59AB photos 59a and 8ba cams rotate in opposite directions, so the teeth on the gears would be in the opposite direction. The crank gear and the cam gear are matched sets.
|
Re: Oil pan 59AB photos Quote:
|
Re: Oil pan 59AB photos So it is only the diretion of the teeth gears correct, I need flip over the both gears teeth?
Thank you so much by the notice. JOrge |
Re: Oil pan 59AB photos Quote:
R |
Re: Oil pan 59AB photos Quote:
http://www.vanpeltsales.com/FH_web/F...timinggear.jpg http://www.vanpeltsales.com/FH_web/F...ngear-alum.jpg http://www.vanpeltsales.com/FH_web/F...m_1940to48.JPG http://www.macsautoparts.com/ford_me...passenger.html http://www.honestcharley.com/hot-rod...-alum-59a.html R |
Re: Oil pan 59AB photos 1 Attachment(s)
Thank you so much Ronnie by the notice and the photos too.
As I don't know of any existing engine near me not always it is clear, my support it is photos that I found in my searches or some help from the members of the forum. Now i believe that is correct, the left that i have, the right it is the new one. The engine that I have been designed it is the 59AB. Thank you all for the help :) All the best, Jorge |
Re: Oil pan 59AB photos Quote:
|
Re: Oil pan 59AB photos Quote:
|
Re: Oil pan 59AB photos Great work that model is really neat! Would you share a .step file of the 59AB intake manifold?
I would love to 3D print one for my desk! Jesse |
Re: Oil pan 59AB photos Quote:
The original poster was last active on this site in 2015 |
All times are GMT -5. The time now is 05:26 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.