Valves Some of my exhaust valves are running .012 do you think that is close enough or shouldI have the valve stems ground down. If I need to what kind of grinder can I buy to do that
|
Re: Valves .010" on intakes isn't too bad, could stand to be a bit looser though.
.20" on the exhaust is crazy loose ! Grinding the stems won't help. There is something drastically wrong like bad camshaft, bad lifters. Unless .20" is just a misprint. Grinding the stem loosens things more. I'm assuming the lifters are original style. |
Re: Valves .010" on the intakes is a bit tight but won't cause any damage because they run cooler than exhausts.
|
Re: Valves My engine rebuilder (Gordon Fischer) suggested for show car i: .011 e: .013
For Driver: i: .010 e: .015 |
All times are GMT -5. The time now is 05:47 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.