horn polarity? Just hooked everything up. As far as I can tell the horn doesn't seem to care about polarity. is this correct?
Also curious if anyone has a good picture of how the stock wiring harness goes from the switch housing to near the radiator. I have it slipped up in between the shell and radiator on drivers side. Seems to look correct but I want to be sure. |
Re: horn polarity? yes on the horn.wire goes behind rad bracket to horn, light across lower rad, should have 3 clips on bottom of rad to hold wire to right head light.
|
Re: horn polarity? I don't think the polarity makes a difference, otherwise the contact points would be identified for such.
If they do.....I goof up every time I connect the wires to the horn. |
Re: horn polarity? Since the horn motor is series wound, polarity doesn't matter. When the armature polarity is reversed (by swapping the 2 wires under the horn clips) the field polarity will be reversed also, so the armature will still spin in the same direction.
|
All times are GMT -5. The time now is 07:57 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.