Vintique 32-36 Open car wiper arm kit Anyone here on the barn "maybe" have a Vintique 32-36 Open car windshield wiper kit sitting around you would like "Possibly" liquidate OR preferably "leftovers" from maybe only using one of the two wiper arms and shaft??? I need one part out of the whole kit and whomever Vintique is having make them for them has changed and doesn't make the one part with the kit anymore and I ordered a whole new kit to get this one part and its not with it SO it would possibly have to be a kit from a few years back or more!!!!! Before I have my machinist make it I figured I'd give the "Barn" a last ditch chance.
Thanks Rockfla |
Re: Vintique 32-36 Open car wiper arm kit Quote:
I might be helpful to post a picture of what your looking for? What part of the kit are you looking for? Regards Sent from my iPad using Tapatalk |
Re: Vintique 32-36 Open car wiper arm kit 5 Attachment(s)
Ask and you shall receive, here is the washer I am seeking.
|
Re: Vintique 32-36 Open car wiper arm kit OD and hole dia Robert?
|
Re: Vintique 32-36 Open car wiper arm kit If it's only the washer and rubber you are looking for, what you are picturing looks very much like Model A Ford windshield swing arm washers. Look at www.Brattons.com part number30140.
|
Re: Vintique 32-36 Open car wiper arm kit Ford used a lot of parts from other years on different models. For example, the part that I recommended for you, is also used on my '46 Woodie, as the lift gate lock anchor. One is used on each side under the swing arm nut, also same as Model A, to hold up the lift gate.
|
Re: Vintique 32-36 Open car wiper arm kit Quote:
|
Re: Vintique 32-36 Open car wiper arm kit While they look the same, it's not the same washer (o.d. too big and i.d. too small).
|
Re: Vintique 32-36 Open car wiper arm kit But it may work for his needs David.
|
Re: Vintique 32-36 Open car wiper arm kit Robert is one of those who prefer sticking to the originals wherever possible.
|
Re: Vintique 32-36 Open car wiper arm kit Rockfla, I may have what your looking for. is the washer 7/8" measuring from the open side. with 1/2" hole
|
Re: Vintique 32-36 Open car wiper arm kit The original was 3/4" o.d. and the hole size was 21/64".
|
Re: Vintique 32-36 Open car wiper arm kit I have the factory WS frame off Mikes 34 phaeton that has the stud assy for a second wiper . Old stuff but the washer you seek is taller than the repop in your pic . Send a pm with a phone number and I will text pics . Posting pics here is not working for me anymore .
|
Re: Vintique 32-36 Open car wiper arm kit The ID by my trusty Mititoyo’s
ID. .345. So 23/64ths is just over OD. .80 so 13/16thz would work OR as amazing DavidG posted, that too!! |
Re: Vintique 32-36 Open car wiper arm kit I just measured one on my '46 Station Wagon, lift gate lock. The O.D. is .814 and the bore, or middle hole is .320, a tad over 3/16".
|
All times are GMT -5. The time now is 09:13 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.