'35 Ford Standard Trunk Seals 1 Attachment(s)
Drake suggested I contact both the EFV8 and FordBarn. FordBarn has always been terrific.
Attached is a screen shot of the trunk seals Drake sells. But no installation info. My car is original and the lower seal (the body not the lid) is missing. But the lid seal has hardened. Any help on which seal goes where, and do I cover the drains on the body with the seal? Thank you. |
Re: '35 Ford Standard Trunk Seals The wider seal 1" wide by 130" long goes on the lid (48-725446) and the narrow seal 3/4" by 130" long goes on the body opening (48-725444).
|
Re: '35 Ford Standard Trunk Seals I always know you have the answer. Thank you x 130.
|
Re: '35 Ford Standard Trunk Seals I feel like Columbo. One more thing...Don, is the u slot face down on the metal for the body seal, and the lid seal... face up against the metal or down? OK. Another one more thing. Do I cover the drain holes on the body seam...Thanks.
|
Re: '35 Ford Standard Trunk Seals Back up to Don Rogers
|
Re: '35 Ford Standard Trunk Seals I believe what Henry is asking is will the U shaped grooves face each other once installed.
|
Re: '35 Ford Standard Trunk Seals Jim, The hollow side goes into the groove so the domed part is facing out.
|
Re: '35 Ford Standard Trunk Seals i've had this same question posted for awhile, no replies. no answer yet on how to deal with it around the two drain holes. anybody? pictures are always the best. . .
|
Re: '35 Ford Standard Trunk Seals My guess is if water got under the U shaped seal it could run down to the drains.
|
Re: '35 Ford Standard Trunk Seals ....
|
Re: '35 Ford Standard Trunk Seals 1 Attachment(s)
Been already answered; but here's a picture I saved when I got the seals.
|
Re: '35 Ford Standard Trunk Seals Quote:
|
Re: '35 Ford Standard Trunk Seals Quote:
|
Re: '35 Ford Standard Trunk Seals Quote:
The trunk seal I have fits snuggly in the groove and has stayed in place without glue for a few years now. The lid seal fits snug; but needs glue to stay there. I stopped it at the drain holes on each side as someone on here posted; but then I put a piece between the holes as I had so much left. I don't know what brand seals I have for sure; thinking Drake. |
All times are GMT -5. The time now is 01:55 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.