The Ford Barn

The Ford Barn (https://www.fordbarn.com/forum/index.php)
-   Model A (1928-31) (https://www.fordbarn.com/forum/forumdisplay.php?f=3)
-   -   Exhaust/Intake gasket (https://www.fordbarn.com/forum/showthread.php?t=1469)

a31vicky 05-13-2010 09:05 AM

Exhaust/Intake gasket
 

I have used a black fiber 1 piece gasket in past with excellent results. Don't remember where I purchased. Does anyone know of a supplier? If not, what is best product currently on market. Thanks. a31vicky

Tom Wesenberg 05-13-2010 09:45 AM

Re: Exhaust/Intake gasket
 

I've only used the copper with filler in the center and had excellent results. I also use the gland rings, except due to slight warpage I can't get the rear one in my 28.

Mitch//pa 05-13-2010 09:53 AM

Re: Exhaust/Intake gasket
 

i use the copper also and usually replace the studs and manifold dish washers and brass nuts. it gives it a clean fresh look


All times are GMT -5. The time now is 05:46 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.