Radius rod ball cap bolts replacement Hello,
Does anyone know of an easier way to replace the bolts that hold the rod cap together other than pulling the motor? One of mine is slightly stripped and the nut wont thread. So I bought a kit and just planning. Thanks in advance! |
Re: Radius rod ball cap bolts replacement You can replace them from under the car. pull the pin and push up then rock them out of the hole. You can use a piece of soft wire to help in putting/guiding the new ones in. A good light helps. If the bore for the bolts is worn you can add a washer or a few under the bolt head to raise it some.
|
Re: Radius rod ball cap bolts replacement Quote:
|
All times are GMT -5. The time now is 02:52 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.