The Ford Barn

The Ford Barn (https://www.fordbarn.com/forum/index.php)
-   Model T (1909-1927) (https://www.fordbarn.com/forum/forumdisplay.php?f=2)
-   -   clutch plate (https://www.fordbarn.com/forum/showthread.php?t=278028)

richie rich 03-16-2020 10:00 AM

clutch plate
 

i have a pin on clutch plate that is stuck down and the clutch finger has a lot of play can i take out the clutch housing bolts to the brake drum so see the damage i do not have the time to pull the engine out and the rear end right now

rotorwrench 03-16-2020 01:50 PM

Re: clutch plate
 

Removing the hogs head can be a bear. Some depends on whether it has a starter or not. The top will come off but other things may need to be removed or moved out of the way to get it off & back on again. I don't know if it will allow much disassembly though. This is one persons procedure. There are likely others too.
http://www.mtfca.com/discus/messages...tml?1348584247

redmodelt 03-16-2020 09:29 PM

Re: clutch plate
 

https://www.mtfca.com/phpBB3/viewtop...p=84113#p84113

fordwife 03-18-2020 03:28 PM

Re: clutch plate
 

My motto is : if you don't have time to do it right, when will you find time to do it over?

fordwife 03-20-2020 05:39 PM

Re: clutch plate
 

I re-read your post, and if I am understanding your problem correctly, the engine-trans will have to come out and the trans will have to be disassembled at least the rear plate that holds the 3 fingers will have to be removed.


All times are GMT -5. The time now is 04:38 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.