Rear Motor Mount Bolts
 

Just sorting out some bolts to install the rear motor mount to the flywheel housing . I have some that would do but are cross drilled for a lock wire and some plain.
Originally were they lock wired or with a lock washer . Just curious .

John in lovely locked down Spring Weather Suffolk County England .

Re: Rear Motor Mount Bolts
 

Originals where drilled to accept cotter (split ) pins.






Quite nice here too in Nassau County, along side Suffolk County, USA


jb

Re: Rear Motor Mount Bolts
 

Per RG/JS, Sec 1-9,
"The heads of the bolts were safety wired in various ways with 18 gauge plain or raven finished wire."
No mention of lock washers....
TallyHo

Re: Rear Motor Mount Bolts
 

Ooops, Should have typed:
Section 1-5 Revised 2011

Re: Rear Motor Mount Bolts
 

The rear engine mounts were bolted to flywheel housing with unfinished bolts AND lock washers and wired with 18 gauge wire which was plain or raven.

Re: Rear Motor Mount Bolts
 

Research the following;

A-21207 Bolt - housing to rear engine support.

A-22330 Lock Washer

A-6402 Wire - engine support to flywheel housing support wire

.
.

Re: Rear Motor Mount Bolts
 

The above are correct......why did I read but think of the smaller motor mount to frame bolts???


Week 6 'Interment Camp Cuomo'.........

Re: Rear Motor Mount Bolts
 

Thank you all very much all is crystal clear . All my cars have lock washers and oddly enough not had any with wire . None are original so many motor changes over the years .

John in yet another glorious Spring Day we are heading for the warmest April on record and no Model A !!! Suffolk County England .