Broken brake adjuster I'm working on a 1946 chassis I picked up, I assume one brake was seized at one point and someone snapped off one of the adjuster bolt in the backing plate. I have the broken bolt, spring, and eccentric tab on the back. Is there a repair kit or anything for this or should I just go ahead and clamp it back together and weld the eccentric back on the bolt?
|
Re: Broken brake adjuster Someone on the HAMB is selling SS springs, if that's not needed weld it back together.
|
Re: Broken brake adjuster I was hoping someone made replacement bolts/eccentric cams as well, I've run across many that were siezed, but backing plates were still good.
Let me know if you find a source. |
Re: Broken brake adjuster I'd weld it, the flat sided end of the shank is usually the part that sheared off, enlarge the hole in the cam and be a little careful welding.
By the way; I've never seen a seized adjuster that a minute or so with a torch wouldn't cure. |
Re: Broken brake adjuster Ralph: I believe the fellow on the HAMB is also selling the bolts in SS or a complete kit for replacement. See if you can search for him.
|
Re: Broken brake adjuster Here's a link to the adjuster kit mentioned above.
http://www.jalopyjournal.com/forum/t...#post-11144830 |
Re: Broken brake adjuster 1 Attachment(s)
Another option:
You could use an adjuster salvaged off a junk backing plate. Grind the upset end off the stud, remove the cam, drill and tap the end of the stud like the one on the left; but leave the pilot like the stud on the right, and reassemble it with a button head cap screw and Lok-tite. |
Re: Broken brake adjuster 1 Attachment(s)
Just so everyone knows repair studs have been available for years. Dick Spadaro marketed ours up until his passing. You can still get them from me. Regards, Ron Hofaker
|
Re: Broken brake adjuster Bump
|
Re: Broken brake adjuster Just an update, I did press it back together and weld it up no problem.
|
All times are GMT -5. The time now is 05:22 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.