Removing 1930 front fenders I need to remove my front fenders to do a frame repair on my 30 coupe. I already have the hood, rad, engine, radiator apron removed. What’s the procedure to remove them? Do I have to loosen all the body bolts or can I just loosen the front under the cowl that mount them?
|
Re: Removing 1930 front fenders Just remove the fasteners that hold the fenders.
|
Re: Removing 1930 front fenders I have found it easier if you loosen the fender bracket to frame bolts. Otherwise it's hard to remove the headlight bar to fender brace bolts.
|
Re: Removing 1930 front fenders I already have the headlight bar off, I forgot to mention that.
|
Re: Removing 1930 front fenders Quote:
|
Re: Removing 1930 front fenders Loosen that front body mount, jack it up a bit, and the fender will slide out. Good luck.
|
Re: Removing 1930 front fenders Quote:
Brent, are 1931 fenders mounted under the body the same way? Sent from my iPhone using Tapatalk |
Re: Removing 1930 front fenders Not Brent but....
No Ford changed to the long splash apron that took care of that in 31 |
Re: Removing 1930 front fenders While you need to jack up the body slightly, you should remove the steering column bracket to the gas tank. Doesn't take much to get a gasoline leak.
|
Re: Removing 1930 front fenders Hello,also sometimes the fuel line and distributor may need to be loosened. There will be four bolts that will need loosen and removed ,one one each side at front of cowl and 3 on each side near outside of floor boards the body to frame webbing may also need changed it’s about $20. for a roll and has to be cut to fit.
|
Re: Removing 1930 front fenders 1 Attachment(s)
YAttachment 455019Note distributor ingnition cable is what want to say .Also photos of bolt areas
|
Re: Removing 1930 front fenders 1 Attachment(s)
|
Re: Removing 1930 front fenders Quote:
Thanks. Sent from my iPhone using Tapatalk |
Re: Removing 1930 front fenders Thanks for the replies! Where is the best place to jack up the front of the body?
|
Re: Removing 1930 front fenders I did it right by the engine mount. Just takes a little.
|
Re: Removing 1930 front fenders Quote:
|
Re: Removing 1930 front fenders 2 Attachment(s)
I finally removed all the bolts, I didn’t see where to remove the one with the yellow arrow. Is this necessary to remove the fenders? Also do I need to remove the rear fenders to jack up the front of the body or is it not required? Still not to sure where it was suggested to lift the front of the body with a 2x4, I assume like I have pictured. Probably making this out to be harder than it is but I don’t want to screw anything up.
|
Re: Removing 1930 front fenders I think I just put a board vertically just inside the frame. You just need 1/32in clearance. This does not involve anything in the rear.
|
Re: Removing 1930 front fenders Get a friend to give the body a slight boost and remove the fender.
|
Re: Removing 1930 front fenders Hello again, if I remember correctly,that bolt is attached to a bracket on outer edge of frame.
|
All times are GMT -5. The time now is 11:44 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.