Cam Degree wheel setup for V8 flathead I've been shopping for a degree wheel to check my cam, but have not seen anything size wise to fit either the crankshaft, or the '40 fan bolt pattern. Any recommendations?
|
Re: Cam Degree wheel setup for V8 flathead In most cases there will be a small amount of fab work to get it bolted to the crank,and fab up a pointer for wheel.
There should be someone here that can walk u through it. In chassis will also add to the difficulty. R |
Re: Cam Degree wheel setup for V8 flathead https://www.amazon.com/JEGS-81622-Pr...B0SXYZ93V3ZSMW
This one seems to have a ton of fitting options. |
Re: Cam Degree wheel setup for V8 flathead I bought a speedway one that came with adapters that fit it to flathead crankshaft--- not the best accuracy as checked on rotary table--- the "printing"was a little off center, but not much more than the width of the printed line
|
Re: Cam Degree wheel setup for V8 flathead Quote:
|
Re: Cam Degree wheel setup for V8 flathead Quote:
|
Re: Cam Degree wheel setup for V8 flathead my mistake---it was summit racing, it was on sale when I got my 6V optima, summit #SUM-G1057-16, it came with bushings that fit the crank bolt , I added a flat washer and it bolts right to end of crankshaft of A, V8
|
Re: Cam Degree wheel setup for V8 flathead You run the chance of it loosening when you turn it backwards.
R |
Re: Cam Degree wheel setup for V8 flathead Quote:
|
All times are GMT -5. The time now is 08:13 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.