Wire looms Does any one have a source for 8mm wire looms? All I have seen are 7mm.
Thanks, Don |
Re: Wire looms Haven't seen any 8mm looms yet.
Vergil |
Re: Wire looms Thanks Vergil, I'll keep looking.
Don |
Re: Wire looms Check with Flathead Jack on his website. I found that many times he has things that the other FH parts suppliers do not carry. However, he does seem to charge somewhat of a premium for his parts, but hey, if he carries things you can't find elsewhere that you really want/need, I would buy from him.
|
Re: Wire looms Thanks John, I have an old catalog somewhere.
Don |
Re: Wire looms 1 Attachment(s)
Quote:
|
Re: Wire looms Quote:
Great looking engine Richard. Vergil |
Re: Wire looms That would be great if you don't mind Richard. It appears that you have them under rather than over which I prefer. Your engine is beautiful by the way.
Thanks, Don |
Re: Wire looms Wire looms look cool but they will cut the spark plug current somewhat due to capacitive leakage.
|
Re: Wire looms Quote:
Thanks for the nice words on the engine. An enormous amount of planning and execution went into it. |
Re: Wire looms I used a set I made up like Richard and made them out of stainless tubing
|
Re: Wire looms Hi Richard, sent you a pm.
Don |
Re: Wire looms Don , i made a set of wire loom like Richard. I used aluminum tubing and buffedit on a buffing wheel. it came out looking like chrome. I got the tubing from McMaster-Carr.com and the aluminum seperators from performance distributors .com
Don't know if it will help , just passing it along steve |
Re: Wire looms Thanks Choiceph, I got a material list and good diagrams from Richard in Florida and will try to make my own as you did.
Regards, Don |
All times are GMT -5. The time now is 11:37 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.